Advertisement
3. Press touch-tone pad to enter 1YES or 2NO , or use cid /vol (
or
) to scroll to 1YES or 2NO . If yes, then MOVE NEAR TO BASE
displays until the handset is moved closer to the base.
DEFAULT SETTING
1 YES 2NO
MOVE NEAR TO
NOTE: If you choose YES all settings in the programmable
BASE
menu return to the factory default settings.
NOTE: Press the exit/answerer button once to keep the
Then the handset displays CONFIRM? 1YES 2NO . Use the touch-
previous setting and return to the main menu.
tone pad to enter 1YES or 2NO , or use cid /vol (
or
) to scroll
4. Press the mute/program button to save your selection, and return
to 1YES or 2NO .
to the main menu. The default setting you choose shows on the
display for two seconds, and you will hear a confirmation tone.
CONFIRM
1 YES 2 NO
DEFAULT SETTING
NOTE: Press the exit/answerer button once to keep the
R
B
previous setting and return to the main menu screen.
EPLACING THE
4. Press the mute/program button to confirm the deregistration.
CAUTION: To reduce the risk of fire or personal injury, use
DE-REGISTER ... displays for 30 seconds, then HANDSET # DE-
only the battery that list on the accessory order form, which
REGISTERED displays for one second. After that the display
is compatible with this unit.
shows HANDSET NEEDS REGISTRATION until the handset is
re-registered.
CAUTION: To ensure the phone/battery performance, use the
21002 charging cradle, 21025 or 21095 base for battery
G
D
-R
LOBAL
E
EGISTRATION
charging only.
If one or more handsets becomes lost, you should de-register all
1. Make sure the telephone is OFF before
handsets to ensure proper system operation. Follow the steps below
you replace battery.
to deregister both handsets at the same time.
2. Remove the battery compartment door.
1. Press and hold the page/int. button on the base until the charge/
3. Disconnect the cord attached to the
page indicator on the base flashes.
battery pack from the jack inside the
2. Press and hold the page/int button on the base again until the
battery compartment and remove the
charge/page indicator on the base flashes rapidly.
battery pack from the handset.
3. Press and release the page/int button on the base once. All
4. Insert the new battery pack and
handsets are deregistered and HANDSET NEEDS REGISTRATION
reconnect the battery plug.
shows in the display.
5. Put the battery compartment door
back on.
IMPORTANT : It is strongly recommended that a handset not
be de-registered unless absolutely necessary.
6. Place handset in the base to charge. If
you don't charge the handset battery
D
properly (for 16 hours) when you first set
EFAULT
up the phone and/or when you install a
As you become familiar with this system, you may prefer to use the
new battery pack, the battery's long-
system's original settings. Follow the steps below to return to the
term performance will be compromised.
factory default settings.
1. Make sure your handset is in menu mode. Make sure your phone
B
S
P
ATTERY
AFETY
RECAUTIONS
is OFF (not in talk mode).
• Do not burn, disassemble, mutilate, or puncture. Like other
2. Press the mute/program button on the handset. DEFAULT SETTING
batteries of this type, toxic materials could be released which can
1YES 2NO shows in display.
cause injury.
3. Use the touch-tone pad on your handset to enter 1YES or 2NO , or
• Keep batteries out of the reach of children.
use the cid/vol (
or
) button on your handset to scroll to 1YES
• Remove batteries if storing over 30 days.
or 2NO . 2NO is the default setting.
H
B
C
I
EADSET AND
ELT
LIP
NSTALLATION
C
O
H
ONNECTING AN
PTIONAL
EADSET TO THE
For hands free conversation.
1. Insert the headset plug into the headset jack.
2. Adjust the headset to rest comfortably on the ear.
3. Move the microphone to approximately 2 to 3 inches from
your mouth.
4. Press the talk/callback button to answer or place a call while using
the headset.
C
B
C
ONNECTING THE
ELT
LIP
There are two slots, one on each side of the handset.
1. Attach the belt clip by inserting the sides of the belt clip into the
slots.
2. Snap the ends of the belt clip into place.
NO
Headset jack
Slot for
belt
ATTERY
clip
Headset plug
G
P
C
ENERAL
RODUCT
ARE
To keep your unit working and looking good, follow these guidelines:
• Avoid putting the phone near heating appliances and devices that
generate electrical noise (for example, motors or fluorescent
lamps).
• DO NOT expose to direct sunlight or moisture.
• Avoid dropping the handset, as well as other rough treatment to
the phone.
• Clean the phone with a soft cloth.
• Never use a strong cleaning agent or abrasive powder because
this will damage the finish.
• Retain the original packaging in case you need to ship the phone
at a later date.
• Periodically clean the charge contacts on the handset and base
with a clean pencil eraser.
C
P
R
What we will do:
AUSES OF
OOR
ECEPTION
• Provide you with a new or, at our option, a refurbished unit. The
• Aluminum siding.
exchange unit is under warranty for the remainder of the original
H
ANDSET
product's warranty period.
• Foil backing on insulation.
• Heating ducts and other metal construction that can shield radio
How you get service:
signals.
• Properly pack your unit. Include any cables, etc., which were
• You're too close to appliances such as microwaves, stoves,
originally provided with the product. We recommend using the
computers, etc.
original carton and packing materials.
• "Proof of purchase in the form of a bill of sale or receipted invoice
• Atmospheric conditions, such as strong storms.
which is evidence that the product is within the warranty period,
• Base is installed in the basement or lower floor of the house.
must be presented to obtain warranty service. " For rental firms,
• Base is plugged into AC outlet with other electronic devices.
proof of first rental is also required. Also print your name and
• Baby monitor is using the same frequency.
address and a description of the defect. Send via standard UPS or
its equivalent to:
• Handset battery is low.
• You're out of range of the base.
S
ERVICE
If trouble is experienced with this equipment, for repair or warranty
information, please contact customer service at 1-800-448-0329. If the
• Pay any charges billed to you by the Exchange Center for service not
equipment is causing harm to the telephone network, the telephone
covered by the warranty.
Slot
company may request that you disconnect the equipment until the
for
• Insure your shipment for loss or damage. ATLINKS accepts no
problem is resolved.
belt
liability in case of damage or loss.
clip
This product may be serviced only by the manufacturer or its
• A new or refurbished unit will be shipped to you freight prepaid.
authorized service agents. Changes or modifications not expressly
What your warranty does not cover:
approved by ATLINKS USA, Inc. could void the user's authority to
• Customer instruction. (Your Owner's Manual provides information
operate this product. For instructions on how to obtain service, refer
regarding operating instructions and user controls. Any additional
to the warranty included in this guide or call customer service at 1-
information, should be obtained from your dealer.)
800-448-0329.
• Installation and setup service adjustments.
Or refer inquiries to:
• Batteries.
ATLINKS USA, Inc.
• Damage from misuse or neglect.
Manager, Consumer Relations
P O Box 1976
• Products which have been modified or incorporated into other
Indianapolis, IN 46206
products.
Attach your sales receipt to the booklet for future reference or jot
• Products purchased or serviced outside the USA.
down the date this product was purchased or received as a gift. This
• Acts of nature, such as but not limited to lightning damage.
information will be valuable if service should be required during the
Product Registration:
warranty period.
• Please complete and mail the Product Registration Card packed
Purchase date _______________________________________________
with your unit. It will make it easier to contact you should it ever
be necessary. The return of the card is not required for warranty
Name of store________________________________________________
coverage.
Limitation of Warranty:
L
W
IMITED
ARRANTY
• THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY
What your warranty covers:
APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF
• Defects in materials or workmanship.
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE)
For how long after your purchase:
ARE HEREBY DISCLAIMED. NO VERBAL OR WRITTEN
• One year, from date of purchase.
INFORMATION GIVEN BY ATLINKS USA, INC., ITS AGENTS, OR
(The warranty period for rental units begins with the first rental or
EMPLOYEES SHALL CREATE A GUARANTY OR IN ANY WAY
45 days from date of shipment to the rental firm, whichever
INCREASE THE SCOPE OF THIS WARRANTY.
comes first.)
• REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS
WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER.
ATLINKS USA, INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF
THIS PRODUCT OR ARISING OUT OF ANY BREACH OF ANY
EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. THIS
DISCLAIMER OF WARRANTIES AND LIMITED WARRANTY ARE
GOVERNED BY THE LAWS OF THE STATE OF INDIANA. EXCEPT TO
THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE
APPLICABLE WARRANTY PERIOD SET FORTH ABOVE.
How state law relates to this warranty:
• Some states do not allow the exclusion nor limitation of
incidental or consequential damages, or limitations on how long
ATLINKS USA, Inc.
an implied warranty lasts so the above limitations or exclusions
c/o Thomson
may not apply to you.
11721 B Alameda Ave.
• This warranty gives you specific legal rights, and you also may
Socorro, Texas 79927
have other rights that vary from state to state.
If you purchased your product outside the USA:
• This warranty does not apply. Contact your dealer for warranty
information.
DESCRIPTION
MODEL NO.
PRICE*
QUANTITY
TOTAL
Belt clip
5-2607
$8.75
Replacement battery
5-2548
$11.90
Headset
5-2425
$36.35
To order, call 1-800-338-0376 (for accessories only) or complete this
order form.
Advertisement
