Pioneer DVR-LX61D Operating Instructions Manual page 140

The Initial Setup menu
18
Setting
AV1 Out
• If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case
either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on
page 170).
• The Component Video Out setting (see page 139) has no effect when AV1 Out is set to RGB.
•
When the HDMI signal is output, the AV1 Out outputs the composite video signal even when it is set to RGB.
AV2/L1 In
NTSC on
PAL TV
Many recent PAL TVs are compatible with NTSC input and so this setting can be switched off. Check the operating
instructions that came with your TV. See also About NTSC on PAL TV on page 151 for related information.
Audio In
NICAM Select
Analog Tuner
Level
External Audio
When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder
whether the audio is stereo or bilingual. This has priority over the setting you make here.
140
En
Options Explanation
Video • Sets the AV1 (RGB)-TV SCART output to standard composite
video (compatible with all TVs).
Sets the AV1 (RGB)-TV SCART output to S-Video.
S-Video
Recommended if you are using a long SCART cable.
Sets the AV1 (RGB)-TV SCART output to RGB. Good quality
RGB
but check your TV for compatibility. Note that on this setting
signals from the built-in tuner and from external inputs is not
output when the recorder is in TV mode.
Sets the AV2 (INPUT 1/DECODER) SCART input to standard
Video •
composite video.
S-Video Sets the AV2 (INPUT 1/DECODER) SCART input to S-Video.
RGB Sets the AV2 (INPUT 1/DECODER) SCART input to RGB.
Decoder Use this setting if you connected a decoder to the AV2
(INPUT 1/DECODER) SCART connector. For scrambled
channels, make sure that the channel Decoder setting is set
to On. (See Manual CH Setting on page 139.)
On • NTSC discs will play correctly on PAL-only TVs.
Off Use if your TV is already NTSC-compatible.
Record the NICAM audio in a NICAM broadcast.
NICAM •
Record the non-NICAM audio in a NICAM broadcast. (You
Regular
Audio can still switch the audio to record using the AUDIO button
before recording.)
Standard setting.
Normal •
Compression Use if the audio level from the built-in tuner is excessive,
causing distortion.
Select if the audio from the currently selected external input
Stereo •
is standard stereo.
Bilingual Select if each channel carries a separate soundtrack.