Table of Contents
Advertisement
DVAS | Instruction Manual | System Menu
9.3 Network Port
Use this page to alter the speed and duplex mode of
the Network port.
The DVAS Series disk array has a 10/100Base-T
Ethernet port that can be used in various modes. Use
the drop down menu to select the required mode.
Mode Selections are:
Figure 40 Network Port Settings
•
Auto negotiate network speed and duplex
•
Auto negotiate network speed with fixed full
duplex
•
Auto negotiate network speed with fixed half
duplex
•
Fixed to 100Megabits Full Duplex
•
Fixed to 100Megabits Half Duplex
•
Fixed to 10Megabits Full Duplex
•
Fixed to 10Megabits Half Duplex
If the DVAS Series disk array is connected to a switch,
you may use full duplex. Half duplex will work
properly with hubs and switches, but may run a little
slower. Only use 100Megabits if you are sure you have
100Megabits networking. If unsure about your
network, use Fixed to 10Megabits Half Duplex.
Click Save Network Port Setting when finished.
To enable the settings, restart the DVAS Series disk
array.
Bosch Security Systems | 20 January 2004
9.4 E-Alert
The DVAS Series disk array has the capability of
sending an e-mail to a specified e-mail address, in the
event of a warning or error condition.
In warning conditions, the DVAS Series disk array
operation continues as normal, but an event has
occurred, indicating potential future difficulties.
Examples are:
•
Higher than normal internal temperature
•
Network IP address change dictated by a
DHCP server (you need to use a new network
address to access the Web Monitor)
Error conditions denote events that significantly reduce
the security of the system. Examples are:
•
Failure of a data disk
•
Loss of data due to errors on matching parts of
two or more disks
•
Failure of a power supply
Figure 41 E-Alert Settings
Sender E-mail Address
This is the e-mail address assumed by the DVAS Series
disk array.
SMTP E-mail Address
This is the address or name of your mail server. If
DNS is correctly set up, enter the name of your mail
server either manually or via DHCP.
Recipient E-mail Address
Enter an e-mail address for the DVAS to send e-mail
to; typically the address of an administrator.
EN | 32
Advertisement
Table of Contents
