Bosch LTC 8555 Instruction Manual page 30

LTC 8555 Series | Instruction Manual | Installation
If using the LTC 8059 Master Control Software, while
online, select the Command Script tab and enter the
script for your connection type exactly as it appears in
the table below:
Keyboard interface
connection type
Direct to Console port
(except LTC 8900)
Direct to Printer port
(except LTC 8900)
Modem connected to
Console port
(except LTC 8900)
Modem connected to
Printer port
(except LTC 8900)
Direct to Controller port
(LTC 8900 only)
Direct to Console port
(LTC 8900 only)
Modem connected to
Controller port
(LTC 8900 only)
Modem connected to
Console port
(LTC 8900 only)
Allegiant system main
CPU bay
User-supplied female
9-pin D connector.
Console pin 2 (Rx) to Tx of link or directly to pin 3 of LTC 8557 box.
Console pin 3 (Tx) to Rx of link or directly to pin 2 of LTC 8557 box.
Console pin 7 (Gnd) to Data Gnd of link or directly to pin 1 of LTC 8557 box.
Figure 6: Direct Connection to Allegiant's Console/Printer Port
Bosch Security Systems | 29 August 2003
Command Script
Begin @boot
SET-PORT-RS232 0 4 8 0 1 0
_SET_KBD_MODE 0 1
break
Begin @boot
SET-PORT-RS232 4 4 8 0 1 0
_SET_KBD_MODE 4 1
break
Begin @boot
SET-PORT-RS232 0 4 8 0 1 1
_SET_KBD_MODE 0 1
break
Begin @boot
SET-PORT-RS232 4 4 8 0 1 1
_SET_KBD_MODE 4 1
break
Begin @boot
SET-PORT-RS232 0 4 8 0 1 0
_SET_KBD_MODE 0 1
break
Begin @boot
SET-PORT-RS232 4 4 8 0 1 0
_SET_KBD_MODE 4 1
break
Begin @boot
SET-PORT-RS232 0 4 8 0 1 1
_SET_KBD_MODE 0 1
break
Begin @boot
SET-PORT-RS232 4 4 8 0 1 1
_SET_KBD_MODE 4 1
break
CONSOLE port on Allegiant
system must be configured
for
RS-232 Keyboard mode
(refer to text for details)
User-supplied cable or other link
suitable for
full duplex RS-232 transmissions
at 9600 baud
After the script has been entered, download the script
into the Allegiant CPU. Reset the system by powering
the CPU off/on, or by entering
on an operating keyboard. The specified port will begin
to operate in the keyboard mode. The port will remain
in the keyboard mode unless manually cancelled by
entering Ctrl-C several times using Windows
HyperTerminal program, operating at 9600 baud.
The keyboard can now be physically connected to
the Allegiant according to details shown in FIGURE 6.
For modem connections, refer to the next section and
FIGURE 7.
Once the keyboard is in communication with the
Allegiant, camera and monitor numbers will appear in
the LED displays.
Junction box and power
adapter supplied with
LTC 8557 kit
EN | 15
Keyboard User Function 15
3 m (10 ft) data/
power cable
supplied with
keyboard