Alarm Inputs In Satellite Systems - Bosch LTC 8600 Instruction Manual

LTC 8600 | LTC 8800 Series

10.7 Alarm Inputs in Satellite Systems

F.01U.127.393 | 2.0 | 2009.03
Any alarm inputs to the main site, which have been programmed to activate cameras
located at satellites, will operate normally except when limited by the number of
trunk lines available. The software automatically determines trunk usage depending
on the priority level of operators currently viewing satellite cameras. Alarm inputs
applied at a satellite site will not activate the alarm video at the main site. If the
application requires alarms located at a satellite to activate video at the main site,
the remote alarms must be brought back to the main site. If necessary, the main
site's LTC 8540/00 Alarm Interface unit can be remotely located via an RS-232 link.
Since the Alarm Interface capability is an integral part of the LTC 8100, LTC 8200,
and LTC 8300 Series, this is not possible if an LTC 8100, LTC 8200, or LTC 8300
Series system is being used as the main site system. If more than one satellite site
contains alarms, multiple LTC 8540/00 Alarm Interfaces can be remotely located.
The number of alarm interfaces which can be remoted is limited only by the capac-
ity of the main site system to support this capability.
Instruction Manual
en | 41
Bosch Security Systems, Inc.