Table of Contents
Advertisement
56
en | Subsystem Maintenance
6.7.2
Replacing a Hard Drive
When a hard drives fails, it needs to be replaced. To replace a hard drive, please follow these
steps:
CAUTION!
The hard drive is fragile—always handle with extreme care. Do not drop the hard drive; always
be slow, gentle, and careful when setting down a hard drive. Only handle the hard drive by the
edges, and avoid touching any components or connectors.
1.
2.
Fig. 6.20 Drive Tray Key-lock Rotation
3.
Fig. 6.21 Front View of an Individual Drive Tray
4.
5.
F.01U.027.799 | V2 | 2008.08
Identify the drive tray that contains the hard drive that needs to be replaced.
Open the key-lock. To remove the drive tray from the enclosure, the key-lock must be
unlocked. (See Figure 6.20) To do this, turn the key-lock on the front of the drive tray
until the groove on its face is in a horizontal orientation.
Open the front flap by pushing the button at the front of the drive tray. (See Figure 6.21)
The drive tray front flap will automatically be lifted and the drive tray will be dislodged
from the chassis.
Remove the drive tray with the hard drive, gently and carefully withdrawing the drive tray
with hard drive from the chassis.
Remove the four (4) retention screws located on the sides of the drive tray (two on each
side.) (See Figure 6.22)
RAID Subsystem DVA-16K | Installation Manual
Bosch Security System
Advertisement
Table of Contents
