Troubleshooting Checklists; Initial System Startup; Checklist - NEC Express5800 320La User Manual

Troubleshooting Checklists

The following subsections provide troubleshooting checklists for problems that occur at
initial system startup, when you run new application software, and after the system
hardware and software have been running correctly.

Initial System Startup

Incorrect installation or configuration usually causes problems that occur at initial
system startup. Hardware failure is a less frequent cause. If you have problems during
initial system startup, review the following checklist.

Checklist

Are the system power cords properly connected to the system and plugged into a
!
NEMA 5-15R outlet (100-120 VAC), a NEMA 6-15R outlet (200-240 VAC), or an
UPS that meets the power specifications of the system?
Is AC power available at the wall outlet?
!
Did you press the power on/off push-button switch on the front panel to turn the
!
system on (power on LED should be lit)?
Are all cables correctly connected and secured?
!
Are all jumpers and switch settings on option boards and peripheral devices correct?
!
To check these settings, refer to the manufacturer's documentation that comes with
them. If applicable, ensure that there are no conflicts; for example, two option boards
sharing the same interrupt.
Are all switch and jumper settings on internal boards and drives correct?
!
Are the CPU modules and I/O modules fully seated in their bays? Refer to
!
subsection Upgrading Your System in chapter 4 for installation instructions?
Are all peripheral devices installed correctly? Refer to subsection Upgrading Your
!
System in chapter 4 for installation instructions?
Are all option boards and disk drives installed correctly? Refer to the Options
!
Boards and Hard Disk Drives subsections of Upgrading Your System chapter 4.
Is the system hard disk drive properly formatted or configured?
!
Is the operating system properly loaded? Refer to the operating system
!
documentation.
Are all drivers properly installed? For information about installing drivers, refer to
!
your Network Operating System Configuration Guide.
Are the configuration settings in BIOS Setup and the SCSISelcet Utility correct? For
!
information about running these utilities, refer to the Configuring Your System
chapter 3.
Problem Solving 5-3