GE 23-11-2129N-002 Owner's Manual And Installation Instructions page 11

5
Install the Case in the Window
Open the window and mark the centerline
A
on the stool.
Mark centerline
Carefully place the case in the window and
B
align the center of the bottom tie bar with the
centerline on the window stool. Do not release
your grip on the case until the window is in its
final position.
Top retainer bar
6
Assemble and Attach the Sill and Support Brackets
Loosely attach the sill brackets to the support
A
brackets with 5/8 long carriage bolts and nuts.
Carriage bolt
Sill bracket
Find the track hole that aligns with the sill
B
bracket on the outer edge of the window sill.
Using the 5/8 long machine screws and nuts
attach the support brackets to the case track
hole on each side.
Close the window until it touches behind the
C
top retainer bar.
Secure the case through the case track into the
D
window stool on each side, using two 1 screws.
Bottom tie bar
Attach both sill brackets to the window sill
C
using a 1 long screw on each side.
Tighten the bolts and nuts on both sides.
D
Support bracket
Nut
NOTE: When finished, use a level to make
sure the case tilts to the outside 1/4 minimum.
This prevents water from entering the room.
Track hole
Sill
Secure to stool
Level
11