Kenmore ELECTRIC WALL OVEN Installation Instructions Manual page 6

IMPORTANT
Do not lift the oven by the door handle.
3. Insert the oven into the cabinet opening. Slide oven
inward leaving 11/2"(3.8 cm) clearance between the oven
and front of cabinet (see Figure 6). Pull the appliance
cable through the hole for it in the cabinet and toward the
junction box while moving the appliance inward.
"" Y2" (3.8 cm)
clearance
between unit
Figure 6
4.Push the oven in and against the cabinet; the oven side
bracket will clip into the mounting bracket installed into
the side of cabinet.
To pull out the oven for servicing you must use the two
tools supplied with the oven. Insert one tool into hole in
each side of oven frame. Holes are visible when door is
opened. After inserting tools pull the oven towards you
(see Figure 7).
5. Lower Trim Installation:
Fix the lower trim in place using the 2 screws supplied in
the mounting holes located on each side trim below the
oven frame (see figure 8). Use a long screwdriver shaft
to reach the side trim mounting holes below the door. If
necessary, you can also remove the oven door (see the
proper section in your Use & Care Guide) to help you fix
the lower trim in place.
supplied
Mounting
bracket
released
Oven removed
from the cabinet
Hole where to
insert the tool
Figure 7
Figure 8