Advertisement

Specifications

FM tuner section
KDC-MP249/ KDC-MP2049/ KDC-MP149 only:
Frequency range:
200 kHz space: 87.9 MHz — 107.9 MHz
50 kHz space: 87.5 MHz — 108.0 MHz
Usable sensitivity (S/N= 26 dB): 11.2 dBf (1.0 μV/75 Ω)
Quieting sensitivity (DIN S/N = 46 dB):
19.2 dBf (2.5 μV/75 Ω)
KDC-3051M/ KDC-315M only:
Frequency range (50 kHz space): 87.5 MHz — 108.0 MHz
Usable sensitivity (S/N = 26 dB): 1.0 μV/75 Ω
Quieting sensitivity (DIN S/N = 46 dB): 2.5 μV/75 Ω
Frequency response (±3 dB): 30 Hz — 15 kHz
Signal-to-Noise ratio (MONO): 63 dB
Stereo separation (1 kHz): 40 dB
AM tuner section
KDC-MP249/ KDC-MP2049/ KDC-MP149 only:
Frequency range:
Band 1 (MW):
10 kHz space: 530 kHz — 1 700 kHz
9 kHz space: 531 kHz — 1 611 kHz
Band 2 (SW1):
5 kHz space: 2 940 kHz — 7 735 kHz
Band 3 (SW2):
5 kHz space: 9 500 kHz — 10 135 kHz /
11 580 kHz — 18 135 kHz
Usable sensitivity (S/N= 20 dB):
MW: 31 dBμ (36 μV) / SW: 32 dBμ (40 μV)
MW tuner section
KDC-3051M/ KDC-315M only:
Frequency range (9 kHz space): 531 kHz — 1 611 kHz
Usable sensitivity (S/N = 20 dB): 36 μV
LW tuner section
KDC-3051M/ KDC-315M only:
Frequency range: 153 kHz — 279 kHz
Usable sensitivity (S/N = 20 dB): 57 μV
Declaration of Conformity with regard to the EMC Directive 2004/108/EC
Manufacturer:
Kenwood Corporation
2967-3 Ishikawa-machi, Hachioji-shi, Tokyo, 192-8525 Japan
EU Representative's:
Kenwood Electronics Europe BV
Amsterdamseweg 37, 1422 AC UITHOORN, The Netherlands
16
Subject to change without notice.
CD player section
Laser diode: GaAIAs
Digital filter (D/A): 8 Times Over Sampling
D/A converter: 24 Bit
Spindle speed: 500 rpm — 200 rpm (CLV)
Wow & Flutter: Below Measurable Limit
Frequency response (±1 dB): 20 Hz — 20 kHz
Total harmonic distortion (1 kHz): 0.01 %
Signal-to-Noise ratio (1 kHz): 105 dB
Dynamic range: 90 dB
MP3 decode: Compliant with MPEG-1/2 Audio Layer-3
WMA decode: Compliant with Windows Media Audio
Audio section
Maximum output power: 50 W × 4
KDC-MP249/ KDC-MP2049/ KDC-MP149 only:
Full bandwidth power (at less than 1 % THD): 22 W × 4
KDC-3051M/ KDC-315M only:
Output power (DIN 45324, +B = 14.4 V): 30 W × 4
Speaker impedance: 4 Ω — 8 Ω
100 Hz ±8 dB
Tone action: Bass:
Middle: 1 kHz ±8 dB
Treble: 10 kHz ±8 dB
Preout level / load (CD): 2 000 mV/10 kΩ
Preout impedance: ≤ 600 Ω
Auxiliary input section
Frequency response (±3 dB): 20 Hz — 20 kHz
Input maximum voltage: 1 200 mV
Input impedance: 10 kΩ
General
Operating voltage (11 V — 16 V allowable): 14.4 V
Maximum current consumption: 10 A
Installation size (W × H × D): 182 mm × 53 mm × 158 mm
Weight: 1.3 kg
This symbol mark indicates that
Kenwood manufactured this
product so as to decrease harmful
influence on the environment.
KDC-MP249
KDC-MP2049
KDC-MP149
KDC-3051M
KDC-315M
CD-RECEIVER
INSTRUCTION MANUAL
© 2010 Kenwood Corporation All Rights Reserved.
GET0672-001A (MW/M2W/M0/M20)

Advertisement

Table of Contents
loading

Summary of Contents for Kenwood KDC-3051M

  • Page 1: Specifications

    Declaration of Conformity with regard to the EMC Directive 2004/108/EC Manufacturer: Kenwood Corporation 2967-3 Ishikawa-machi, Hachioji-shi, Tokyo, 192-8525 Japan EU Representative’s: Kenwood Electronics Europe BV Amsterdamseweg 37, 1422 AC UITHOORN, The Netherlands © 2010 Kenwood Corporation All Rights Reserved. GET0672-001A (MW/M2W/M0/M20)
  • Page 2: Table Of Contents

    Kenwood dealer. Selecting a folder/track/file When you purchase external components, Direct Music Search using the remote check with your Kenwood dealer to make controller (RC-405) sure that they work with your model and in Listening to the other external your area.
  • Page 3: Preparation

    If swallowed contact physician immediately. Remote controller (RC-405) is equipped for KDC-MP249/ KDC-MP2049. KDC-MP149/ KDC-3051M/ KDC-315M The label is attached to the chassis/case can also be remotely controlled with an and says that the component uses laser optionally purchased remote controller.
  • Page 4: Basic Operations

    Detaches the faceplate The following indicator lights up when... ST: A stereo broadcast is received (FM). IN: A disc is in the unit. KDC-3051M/ KDC-315M only: TI: Traffic Information function is turned on. RDS: RDS service is available. Maintenance Cleaning the unit: Wipe off the dirt on the panel with a dry silicon or soft cloth. Failure to observe this precaution may result in damage to the monitor or unit.
  • Page 5: Muting Upon Reception Of Phone Call

    When you press or hold the following button(s)... Remote Main unit General operation controller Turns on. — Turns off if pressed and held. Selects the available sources (TUNER, CD, AUX, STANDBY), if the power is turned on. • If the source is ready, playback also starts. “CD” is selectable only when a disc is loaded.
  • Page 6: Getting Started

    P-OFF WAIT Sets the duration when the unit will automatically turns off (while in standby mode) to save the battery. –––– : Cancels ; 20M *: 20 minutes ; 40M: 40 minutes ; 60M: 60 minutes [TDF ALARM] is selectable only with KDC-MP249/ KDC-MP2049/ KDC-MP149. [RUSSIAN SET/ P-OFF WAIT] is selectable only with KDC-3051M/ KDC-315M.
  • Page 7: Listening To The Radio

    (not applicable if “MW/ LW” is selected). Hold for about 2 seconds to memorize the current station (or the selected Program Type for KDC-3051M/ KDC-315M). (Refer to [PTY SEARCH] on page 8 to select the Program Type.) Press briefly to recall memorized station (or Program Type after entering the PTY search mode for KDC-3051M/ KDC-315M).
  • Page 8: Adjust [Settings] Mode Settings

    ON *: Automatically searches for a station with better reception when the traffic information's reception is poor. ; OFF: Cancels. [PTY SEARCH/ NEWS SET/ AF SET/ RDS REG/ ATP SEEK] is selectable only for KDC-3051M/ KDC-315M. [PTY SEARCH] is selectable only when the source is “FM.”...
  • Page 9: Listening To A Disc

    Listening to a disc Ejects the disc. (“NO DISC” appears and “IN” indicator goes off.) Press to select track/file. Hold to fast-forwards/reverses. Press to select next folder. 1 Press SRC to turn on the power. 2 Insert a disc into the loading slot. Playback starts automatically.
  • Page 10: Direct Music Search Using The Remote

    Direct Music Search using the Discs that cannot be used remote controller (RC-405) Discs that are not round. Discs with coloring on the recording • Not available if Random Play or Scan Play is surface or discs that are dirty. selected.
  • Page 11: Function Settings

    Function settings 1 Press the volume knob to enter [FUNCTION] mode. 2 Turn the volume knob to select [AUDIO CTRL] or [SETTINGS], then press to enter. 3 Turn the volume knob to make a selection, then press to confirm. See table below for selection. Repeat step 3 until the desired item is selected/activated.
  • Page 12: Troubleshooting

    OFF) RDS SET NEWS SET/ AF SET/ RDS REG/ ATP SEEK: Selectable only if any source other than tuner source is selected. (For details, refer page 8.) [TIME SYNC/ RDS SET] is selectable only with KDC-3051M/ KDC-315M. Troubleshooting Symptom Remedy/Cause Sound cannot be heard.
  • Page 13: Installation/Connection

    If you experience problems during Be sure to ground this unit to the car's installation, consult your Kenwood dealer. chassis again after installation.
  • Page 14: Wiring Connection

    Antenna terminal KDC-3051M/ KDC-315M Light blue/yellow KDC-MP249/ KDC-3051M/ KDC-315M : To the steering wheel remote control adapter (optional accessory) (Steering remote control wire) To the terminal that is grounded when either the telephone rings Brown or during conversation. (To connect the Kenwood navigation (Mute control wire) system, consult your navigation manual.)
  • Page 15: Installing The Unit

    ISO connectors Connecting the ISO connectors on some VW/Audi or Opel (Vauxhall) automobiles Color and function You may need to modify the wiring of the supplied wiring Yellow Battery harness as illustrated below. Blue/White Power control Ignition (ACC) Ignition wire (Red) A7 (Red) Black...

This manual is also suitable for:

Kdc-315mKdc-mp149Kdc-mp2049Kdc-mp249

Table of Contents