Trim Set (Setting Trim Angle); Display (Setting Displays) - Yamaha 6Y8- 2819U-00 Owner's Manual

TRIM 0SET (setting trim angle)/DISPLAY (setting displays)
TRIM 0SET (setting trim angle)
You can set the trim angle to zero. Fully trim
the outboard motor down.
1. Turn the engine off and the engine start
switch to ON.
2. (4 seconds): To activate the cus-
tom mode.
3. : To switch between the setting
function names.
4. : To switch to the zero adjustment
display.
5. + (1 second): To adjust the
trim angle to zero using the current trim
position as the standard value.
6. (1 second): To return to the nor-
mal display.
NOTE:
Press the button for 1 second from
step 4 to cancel the adjustment of the trim
angle to zero and return to the custom mode
selection display.

DISPLAY (setting displays)

You can change the display configuration of
the normal display. There are a total of 16
combinations of which up to four displays
can be set up.
The display configuration numbers that have
been selected as the default display config-
uration are indicated by the shaded areas
in the table below.
00 —
01
—
02
03
04
05
—
06
—
07
—
08
—
09
10 —
—
11
12
—
13
—
14
—
15
—
16
: Displayed
Changing the display configurations:
1. Turn the engine off and the engine start
switch to ON.
13
— — —
—
— —
— —
— — —
—
—
— —
—
— —
— —
— — —
— —
— —
— —
— — —
—
—
—
—
—
—
—
—
—
—
—
—