Connecting To Plumbing Facilities - GE 49-90382 Installation Instructions Manual

Installation Instructions
MOVING SPACEMAKER T_ TO OPERATING
LOCATION
_ emove the 2 screws securing the access panel
to the drger cabinet. Lift the front access panel
until the tabs can be disengaged from the drger
cabinet, and remove the panel.
_ oute the inlet hoses, drain hose and power cord
through the rear access area for temporarg
holding when moving the appliance to the
operating location.
L -----;
panel
screws
To ensure the Laundrg Center is level and solid
on all four legs, tilt the Laundrg Center forward
so the rear legs are off the floor. Gentlg set the
Laundrg Center back down to allow the rear legs
to self-adjust. Place a level on top of the washer.
Check it side to side, then front to back. Screw
the front leveling legs up or down to ensure the
Laundrg Center is resting solidlg on all four legs
(no rocking of the Laundrg Center should occur).
NOTE: Keep the leg extension at a minimum to prevent
excessive vibration.
CONNECTING TO PLUMBING FACILITIES
--A CAUTION: Be sure w oter supply lines hove
been thoroughlg flushed to remove particles that
might clog the wesher filter screens.
Check inlet hoses to ensure the rubber washers
are installed in each end. (If gour laundrg center
has the hoses attached to the water valve,
proceed to Step !3A.) Carefullg connect the inlet
hoses to the water valve (on the left side of the
washer cabinet), tighten bg hand, and then
tighten another 2/3 turn with pliers.
_ACAUTION: DO NOT CROSS-THREAD
OR
OVERTIGHTEN THESE CONNECTIONS.
_ etermine which water faucet is the HOT water
faucet, carefullg connect the bottom inlet hose
to the HOTwater faucet, tighten bg hand,
and then tighten another 2/3 turn with pliers.
Carefullg connect the top inlet hose to the
COLD water faucet, tighten bg hand, and then
tighten another 2/3 turn with pliers.
-_CAUTION: Do NOT CROSS-THREAD OR
OVERTIGHTEN THESE CONNECTIONS.
Turn the water on and check for leaks at both
connections.
_ Place formed end of drain hose in drain facilitg
and secure with cable tie (provided in literature
package).
Cord length
4 ft.
!
"Cable tie abl;_ii_[.__
NOTE: Drain hose MUSTbe secured to drain facility in
all cases.
3