Advertisement
INSTALLATIONINSTRUCTIONS
Gather the required tools and parts before starting installation.
Read and follow the safety instructions provided with any tools
listed here.
Tools needed:.
#2 Phillips and flat-blade
•
Wire stripper (direct wire
screwdriver
installations)
Adjustable wrench that
•
Knife
opens to 1" (2.5 cm) or
9/16"(14 mm) open-end
wrench (for adjusting
dryer feet)
Level
1/4"nut driver or socket
wrench
•
Scissors
•
Vent clamps
•
Caulking gun and
compound (for installing
new exhaust vent)
•
Pliers
•
Wood block (for leveling)
•
Tin snips (for new vent
•
Ruler or measuring tape
installations)
Parts supplied:
Remove parts package from the washer basket. Check that all
parts were included.
A
C
D
Your installation may require additional parts. For ordering
information, please refer to your Use and Care Guide.
If You Have
You Will Need to Buy
Laundry tub or
Sump pump system (if not already
standpipe taller than
available)
96" (2.4 m)
1" (2.5 cm) diameter
2" (5 cm) diameter to 1" (2.5 cm)
standpipe
diameter standpipe adapter, Part
Number 3363920
Overhead sewer
Standard 20 gal. (76 L) 34" (86.4 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain
Siphon break, Part Number 285320,
additional drain hose, Part Number
285702 and connector kit,
Part Number 285442
Drain hose too short
Drain hose, Part Number 285664 and
connector kit, Part Number 285442
Lint clogged drain
Drain protector, Part Number 367031
Water faucets
2 longer water fill hoses:
beyond reach of fill
6 ft (1.8 m) Part Number 76314,
hoses
10 ft (3.0 m) Part Number 350008
E
_J F
G
A. Water inlet hoses (2)
B. Inlet hose flat washers (4)
C. Rear leveling legs (2)
D. Front leveling legs (2)
E. Plastic strap
F Drain hose
G. Yellow, single wire hose clamp
H. Silver, double wire hose clamp
Parts needed:
Check local codes. Check existing electrical supply and venting,
and see "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your washer/dryer. For further information, please reference your
Use and Care Guide.
Explosion
Hazard
Keep flammabme materiaBs and vapors, such as
gasoline,
away from dryer.
Failure to do so can result in death, expmosion, or fire.
You will need
•
A location that allows for proper exhaust installation. See
"Venting Requirements."
•
Aseparate30-amp
circuit.
•
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the washer/dryer.
See "Electrical Requirements."
Advertisement
