Kenmore 2661532 Use & Care Manual page 8

I[1 STATUS lights II! START
The STATUS lights show thestage thewasher i sin.Whenthe
selector k nobissetto a newcycle, t heSTATUS lights will flash
momentarily, showing t hestages t hecyclewill go through.
STATUS light Illuminates
ON Whenthefabricsoftener optionhasbeen
selected.
WASH Whenthewasher i s inthewash portion of
thecycle.
RINSE Whenthewasher i s intherinse portion of
thecycle.
SPIN When the washer draining and/or spinning.
LID LOCKED When the washer lid is locked. This feature
prevents the lid from being opened while
the washer is in the spin cycle or coasting to
a stop.
NOTE: If the STATUS lights are blinking, the operation of the
washer has been paused. To resume operation press the
START button (the lid must be closed).
I1_ Temperature
Select the water temperature for the wash and rinse cycles.
Always follow fabric manufacturer's care label or instructions
when laundering.
Automatic Temperature Control senses the incoming water
temperature and adjusts the fill water to obtain a more pre-
cise temperature range for all wash temperatures. For ex-
ample, in a COLD wash selection, some warm water may be
added to reach a temperature needed to better dissolve de-
tergents. Often, detergents are not completely dissolved in
very cold water, especially in cooler climates.
During winter months, when the water entering your home is
colder, or for locations with very cold water year round, use
the Automatic Temperature Control COLD to help dissolve
powdered detergents and to improve the cleaning of your
clothes.
The TAP COLD feature turns the Automatic Temperature
Control feature on your washer off, and uses your household
tap water temperature for a COLD wash. This can provide
energy savings by reducing the amount of hot water used in
your wash.
Press START to begin the cycle. With the lid closed pressing
START again will PAUSE the cycle and STATUS lights will
blink. To continue the cycle, close the lid and press START
again. The water fill will continue with the lid opened, except
when AUTO LOAD SENSING is selected as the load size.
(The lid must be closed to continue filling when AUTO LOAD
SENSING is selected.)
If the lid is opened during the cycle, the cycle will PAUSE
and the STATUS lights will blink. To resume the cycle, close
the lid and press START.
If the machine is paused for more than 24 hours, the cycle
will be cancelled. To stop the cycle, turn the Cycle Selector
to the OFF position.
Iit Load Size
Loosely load clothes no higher than the top row of holes in
the washer basket.
AUTO LOAD SENSING- This selection automatically pro-
vides the correct amount of water suited to the size and type
of load placed in the unit.