Panasonic Arbitrator-CP Reference Manual page 30

[Step 1] Get a setting configuration file from the VPU which settings need to
be copied to other VPUs.
(1) Plug an USB memory*
(2) Go to "Operations" in "Admin" menu by Control Panel and select "Menu Copy".
(3) Press "Copy" button if you agree to copy menu settings to the USB memory.
*This action creates a setting configuration file in the USB memory.
configuration file
[Step 2] Copy the settings to the 2
(1) Plug the USB memory stored a setting configuration file at [Step 1] to the 2
(2) Leaving the P2 card slot cover open,
(2)
until the "Ready" or "Busy" lamp starts to flash (about 10 seconds or more).
Keep pressing
REC button
(8) Menu (VPU settings) Copy
to the VPU which settings need to be copied to other VPUs.
because even if inserting a P2 card instead to the VPU, it cannot be created in the P2 card.
nd
press and hold the REC button
(3) "Ready" light will flash and "Busy" lamp will light. Press the "Stop"
button on VPU when the "Rec" light starts flashing.
(4) After pressing "Stop" button, the 2
the same menu setting as the VPU of [Step 1].
Please use the USB memory to get the setting
VPU.
nd
VPU will reboot and can see
nd
VPU.
nd
on the 2 VPU