Kenmore 30 Owner's Manual page 4

Grounding Requirements
Use of Extension Cords
Because of potential safety hazards under certain
conditions, we strongly recommend against the use
of an extension cord. However, if you still elect to use
an extension cord, it is absolutely necessary that it be a
UL-listed, 3-wire grounding type appliance extension
cord having a grounding type plug and outlet and that
the electrical rating of the cord be t5 amperes
(minimum) and 120 volts.
Use of an extension cord wilt increase the clearance
needed for the back of' the refrigerator.
Electrical Requirements
The refrigerator should always be plugged into its
own individual electrical outlet which has a voltage
rating that matches the rating plate.
This provides the best performance and also prevents
overloading house "wiring circuits "which could cause a
fire hazard from overheated wires.
Refrigerator mnstallation
Location
* Install the refrigerator on a floor strong enough
to support it when it is fully loaded.
o Do not install it where the temperature will
go below 60°E (I 6°Co) because it will not run
often enough to maintain proper temperatures.
° Do not install it next to your range, a heating
vent or where the sun will shine directly on it.
Clearances
Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
B
i
30 Model 24 Model
A: Sides ........... 1/8" (3 mm) 1/8" (3 mm)
B: Top ........... t/8" (3 mm) 1" (25 mm)
C: Back ........... I/2" (13 mm) t!2" (1.3 ram)
(If built-in, allow 7/8" [22 mm] at top for hinge cove_s.)
If' the refrigerator is against a wall on either side, allow
3/4" (19 mm) for door clearances.