Troubleshooting Of Minor Faults - Bosch WFMC220BUC Operating Instructions Manual

Troubleshooting of Minor Faults
TO AVOID RISK OF ELECTRIC
SHOCK!
Repairs should only be carried out
by an authorized technician.
Fault
Thedoorcannotbe
opened.
If repairs are necessary, and you
cannot eliminate the fault yourself with
the aid of the following table:
E:::I Turn the program selector to Off.
E:::I Disconnect the washing machine
from the power outlet.
E:::I Turn off the water taps.
E:::I Call Customer Service
(refer to Page 28).
Action
Doorcannotbe opened,
eventhoughthe appliance
has beenswitchedoff and
on again.
Contmllightsdo notlight
up,
Programdoesnotstart.
Start/Pause indicatorlight
flashes.
Programdoesnotstart.
Indicatorlight "end" is lit
and displayis flashing
"E:Ol"
Spinspeedcannotbe
selected.
Detergentresiduein the
detergentdispenser.
Waterdoesnotenterthe
machineor detergentis not
washedaway.
Indicatorlight "spin" is lit
and displayis flashing
"E:11" or "E:12",
Watercannotbe seen in
drum.
Possible cause
"Nofinal spin" selected. (Doesnotapplyto 500 Plus SelectDrainor Spin.
Series).
Powerfailure.
Programis runningand/orthe dooris lockedfor safety
reasons.
Plugis looseor notinserted.
Programselectorturnedto Off beforeend of program.
Forsafetyreasons the doorhas beenlockedbecause the
waterlevel,temperature or speedis too high.
A fuse hasblown.
Powerfailure.
Start/Pause buttonnot pressed.
Doornotclosedproperly.
Spinning is alreadyin progress;duringspin cyclethe
speedcannotbe changed.
Programselectoris set to drain; spincycleis notpossible
with this program.(Does not apply to 500 Plus
Series). 1
Detergent w as dampor lumpy.
Watertap(s)notturnedon.
An interrupted programwill be resumedwhenpoweris
restored.If the laundryis to be removed duringa power
failure,call Customer Service
(referto Page28).
Wait untilthe programends;see Page24.
Eliminate the cause.
Selecta program.
See "Adda garment/Interrupting the program",Page23.
Resetcircuitbreaker.
CallCustomer Service if this fault recurs.
An interrupted programwill be resumedwhenpoweris
restored.If the laundryis to be removed duringa power
failure,call Customer Service
(referto Page28).
Pressthe Start/Pause button.
Checkwhetherlaundryis trappedin door.
Closethe door(a click shouldbe heard).
Programcontinues.
Selectspeedbeforespinning.
If required,selectanotherprogram.
Supplyhosekinkedor pinched.
Strainers in supplyhoseclogged.
Waterpressure too low.
This is not a fault.
Thewater levelis belowthe visiblepartof the drum.
Cleanand drythe detergentdispenser; s eePage24.
Usethe capof the detergentbottleto measureliquid
detergents.
Turnon watertap(s)and pressStart/Pause button.
Programcontinues.
Eliminate the cause.
Cleanthe water inletstrainers;seePage24.
Eliminate the cause.
26