Waking the Mobile Computer
The wakeup conditions define what actions wake up the mobile computer after it has gone into suspend mode. The
mobile computer can go into suspend mode by either pressing the Power button or automatically by Control Panel
time-out settings. These settings are configurable and the factory default settings are shown in
Table 1-3
Wakeup Default Settings
Condition for Wakeup
AC power is applied.
Mobile computer is inserted into a cradle.
Mobile computer is removed from a cradle.
Mobile computer is connected to a serial device.
Mobile computer is connected to a USB device.
Mobile computer is disconnected from a USB device.
A key is pressed.
The scan triggered is pressed.
The screen is touched.
Wireless LAN activity is detected.
Main Battery Removal
Before removing the main battery, turn off the mobile computer.
To remove the main battery:
Rotate the latches to the open position.
1.
Do not lift up on the latches when removing the Strap/Door Assembly. Lift up on the hand strap only.
CAUTION
Lift the hand strap to lift the Strap/Door Assembly off, bottom first.
2.
CAUTION
On the MC3090G battery, do not remove the battery pull tab. The pull tab is for enabling easy battery
removal from the device.
Release battery:
3.
a. On the MC3000S/R, release the battery clip (at the top of the battery) and lift the battery out top first.
b. On the MC3090G, pull the battery pull tab to unclip the battery and lift the battery out top first. If the battery
does not have a pull tab, use the stylus to unclip the battery and then lift the battery.
Power Button
No
No
No
No
No
No
No
No
No
No
Getting Started 1 - 13
Table
1-3.
Automatic Time-out
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
No