there are no custom defaults, it will reset the scanner to the factory default set-
tings. Any settings that have not been specified through the custom defaults
will be defaulted to the factory default settings.
Note: If using a cordless system, scanning this bar code also causes both the
scanner and the base or Access Point to perform a reset and become
unlinked. The scanner must be placed in its base to re-establish the link.
If using an Access Point, the linking bar code must be scanned. See
Cordless System Operation
information.
Resetting the Factory Defaults
This selection erases all your settings and resets the scanner to the
original factory defaults. It also disables all plugins .
If you aren't sure what programming options are in your scanner, or you've
changed some options and want tto restore the scanner to factory default set-
tings, first scan the Remove Custom Defaults bar code, then scan Activate
Defaults. This resets the scanner to the factory default settings.
Remove Custom Defaults
Note: If using a cordless system, scanning the Activate Defaults bar code also
causes both the scanner and the base or Access Point to perform a reset
and become unlinked. The scanner must be placed in its base to re-
establish the link before any setup codes are entered. If using an Access
Point, the linking bar code must be scanned. See
Operation
The
Menu Commands,
for each of the commands (indicated by an asterisk (*) on the programming
pages).
1 - 10
Activate Custom Defaults
beginning on page 3-1 for additional information.
beginning on page 11-5 list the factory default settings
beginning on page 3-1 for additional
Activate Defaults
Cordless System