Setting The Rear Output; Switching The Muting/Attenuation Timing - Pioneer AVIC-F30BT Operation Manual

Customising preferences
A picture is enlarged by the same propor-
tion as "Full" or "Zoom" in the horizontal di-
rection and by an intermediate proportion
between "Full" and "Zoom" in the vertical
direction; ideal for a cinema-sized picture
(wide screen picture) where captions lie
outside the frame.
! Zoom (zoom)
A 4:3 picture is enlarged in the same pro-
portion both vertically and horizontally;
ideal for a cinema-sized picture (wide
screen picture).
! Normal (normal)
A 4:3 picture is displayed normally, giving
you no sense of disparity since its propor-
tions are the same as that of the normal
picture.
p You can only adjust "Wide Mode" when se-
lecting an AV source with video.
p Different settings can be stored for each
video source.
p The same setting is automatically applied
for the following grouping.
! DVD-V and DivX
! AV1 and AV2
p When viewing videos, select an appropriate
wide screen mode that matches its original
aspect ratio to view it comfortably.
p Remember that use of this system for com-
mercial or public viewing purposes may
constitute an infringement on the author's
rights protected by the Copyright Law.
p The navigation map and the rear view cam-
era picture is always viewed at "Full".

Setting the rear output

The navigation system's rear output can be
used for a full-range speaker or subwoofer
connection. If you switch "Rear SP" to
"Sub. W", you can connect a rear speaker lead
directly to a subwoofer without using an auxili-
ary amp.
Initially, the navigation system is set for a rear
full-range speaker connection ("Full").
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)
p "Rear SP" can be set only when the source
is selected to "Off".
p AVIC-F9310BT is not compatible with the
wiring that the subwoofer is directly con-
nected to rear speaker leads. Always use
the setting with "Full".
1 Display the "AV System Settings"
screen.
= For details, refer to Displaying the screen for
AV system settings on page 147.
2 Touch [Rear SP].
Each touch of [Rear SP] changes the settings
as follows:
! Full
When no subwoofer is connected to the
rear output, select "Full".
! Sub. W
When a subwoofer is connected to the rear
output, select "Sub. W".
Switching the muting/
attenuation timing
You can mute the AV source volume or attenu-
ate the output signal.
p Even if this setting is "Off", the navigation
system will mute or attenuate the AV
source volume when the mute signal is out-
put via MUTE lead.
1 Display the "AV System Settings"
screen.
= For details, refer to Displaying the screen for
AV system settings on page 147.
2 Touch [Mute].
Each touch of [Mute] changes the settings as
follows:
AVIC-F30BT
! Guide/Tel/VR: The volume is muted or atte-
nuated according to the following condi-
tions.
Chapter
26
149
Engb