Configuring The Function Key Operation; Using The Touch Screen (Select Models Only); Tapping (Or Clicking); Flicking - HP Mini 5103 User Manual

Configuring the function key operation

To configure the function key operation to require the use of the
steps:
1. Open Computer Setup by turning on or restarting the computer, and then pressing
"Press the ESC key for Startup Menu" message is displayed in the lower-left corner of the screen.
2. Press f10
3. Select the System Configuration menu.
4. Select the Device Configurations menu.
5. Select Fn Key Switch, and then select Enable.
6. Press f10
7. To save your preferences and exit Computer Setup, use the arrow keys to select File > Save
changes and exit. Then follow the instructions on the screen.
Your preferences go into effect when the computer restarts.

Using the touch screen (select models only)

Some computer models allow you to use your fingers to perform certain actions on the touch screen.
NOTE: The instructions in this section are based on factory settings. To modify settings for recognized
clicks and flicks, select Start > Control Panel > Hardware and Sound > Pen and Touch.
NOTE: All movements may not be supported in all programs.

Tapping (or clicking)

Tap or double-tap an item on the screen as you would click or double-click using a TouchPad or an
external mouse. Tap and hold an item to see the context menu as you would use the right TouchPad
button.
NOTE: You must tap and hold your finger until a circle appears around the area you are touching, and
then the context menu is displayed.

Flicking

Touch the screen in a light, quick flicking motion up, down, left, or right to navigate through screens or
quickly scroll through documents.
NOTE: For the flicking movement to work, a scrollbar must be visible in the active window.
to enter BIOS Setup.
to accept the changes you have made.
fn key (fn + function key), follow these
Configuring the function key operation
esc while the
77