Using the Alert Manager
36
For the destination settings, make the following settings.
[Internet Mail Destination Setting] dialog
– [To]:
Type in the E-mail address (To:) in the form user@domain.
Be sure to divide it with , (comma) when you specify plural addresses (e.g.
abc@Zzz.Com, xyz@Zzz.Com).
– [Subject]:
Enter a title of the mail.
– [Message Head]:
To send a message, enter information. Message contents of actual mail consist of this
message header and alert information.
– [Enable]:
Mark this check box when you send mail through Remote Access Service (RAS).
NOTE:
Service. Additionally, set an entry for the Remote Access Service. If
the entry for the Remote Access Service is not set, this check box
cannot be marked.
– [Entry to Use]:
Select a Remote Access Service entry from the list.
Before setting the destination, configure the Remote Access