Samsung 6 series User Manual page 29

If Security Key is not set: When security setting of AP that supports WPS is NONE, you can select PBC, PIN, None Security.
●
None Security is capable of connecting to AP directly without using WPS function.
Process of PBC, PIN is same as above. Refer to In case Security Key is already set.
N
Try again if connecting operation doesn't work.
N
Ad-hoc: You can connect to a mobile device without an access point through the 'Samsung Wireless LAN adapter' by
–
using a peer to peer network .
How to connect to new Ad-hoc
. Choose Select a network, then a device list is displayed.
. While in the device list, press the Blue button on the remote or select Ad-hoc.
The message that means the existing network is disconnect is displayed.
N
. Input the generated Network Name(SSID) and Security Key into the device yon want to connect.
How to connect an existing Ad-hoc device
. Choose Select a network, the device list is displayed.
. Select the device you want in the Device list.
. If security key was applied, input the security key again.
If network doesn't operate normally, please check the Network Name(SSID) and Security Key
N
again. If the Security Key is incorrect, it may be the reason of malfunction.
Wireless Network Setup-Auto Setup
If you want to connect AP, AP should support DHCP. Only devices which support Ad-hoc mode can be connected without DHCP.
. Set Network Type to Wireless.
. Select Network Setup.
. Set Internet Protocol Setup to Auto Setup.
The Internet Protocol is set automatically.
N
. Select a network through Select a network.
. Select Network Test to check the network connectivity.
Wireless Network Setup-Manual Setup
. Set Network Type to Wireless.
. Select Network Setup.
. Set Internet Protocol Setup to Manual Setup.
. Set up IP Address, Subnet Mask, Gateway and DNS Server.
Press the number buttons on the remote control when you set the Network manually.
N
. Select a network through Select a network.
. Select Network Test to check the network connectivity.
English -