Care And Cleaning Car E And Cleaning E And Cleaning; Filters; Lights - Electrolux 316488522 Installation, Use & Care Manual

Care and cleaning
The efficiency of the range hood system depends on
the cleanliness of the intake and filters.
The frequency of cleaning depends on the amount
and type of cooking.
• Do not use the ventilating system without the
filters in place or with grease-laden filters or
surfaces.
To avoid risk of fire and explosion do not use
flammable liquids or solvents.
Always unplug or disconnect the appliance from the
power supply before servicing.
Be sure the entire hood (including the filters and light
bulbs) has cooled and grease has solidified before
attempting to clean any part of the appliance.

Filters

Filters Filters
Filters Filters
The metal grease filters are made of stainless steel
anodized aluminum and are long lasting.
T T T T T o Remove The Metal Gr o Remove The Metal Gr o Remove The Metal Gr o Remove The Metal Grease Filters o Remove The Metal Gr ease Filters ease Filters ease Filters ease Filters
• Turn the fan and lights off.
• Pull the spring release handle.
T T T T T o Replace The Metal Gr o Replace The Metal Grease Filters o Replace The Metal Gr o Replace The Metal Gr o Replace The Metal Gr ease Filters ease Filters ease Filters ease Filters
• Reverse procedure.
T T T T T o Clean Filters o Clean Filters o Clean Filters o Clean Filters o Clean Filters
• • • • • It is recommended that the filters be washed at
least once a month; they can be washed by hand
or in the dishwasher.
• Drain water through edge holes and let each filter
dry thoroughly before replacing it.
Care and cleaning

Lights

Lights Lights Lights Lights
Before replacing the lamps, switch power off at
service panel and lock service panel disconnecting
means to prevent power from being switched on
accidentally.
NOTE: Tur ur ur ur urn of NOTE: T NOTE: T NOTE: T NOTE: T n off the lights and fan. Allow the lights n of n of n of f the lights and fan. Allow the lights f the lights and fan. Allow the lights f the lights and fan. Allow the lights f the lights and fan. Allow the lights
to to to to to cool cool cool cool cool befor befor befor befor before handling. e handling. If new lights do not e handling. e handling. e handling. If new lights do not If new lights do not If new lights do not If new lights do not
operate be sure lights ar operate be sur operate be sur e lights are inserted corr e lights ar e lights ar e inserted corr e inserted corr e inserted correctly befor
operate be sur operate be sur e lights ar e inserted corr
calling service. calling service. calling service. calling service. calling service.
Replace Lights Replace Lights Replace Lights
Replace Lights Replace Lights
• Remove the inner lamp lens cover by inserting a
small flat blade screwdriver into each of the three
slots and gently prying it free.
NOTE: Do not remove the outer trim ring (lamp
assembly).
• Grasp the bulb and pull it straight out.
• Replace with 12 volt, 20 watt halogen bulbs with
a G4 base SUITABLE FOR USE IN OPEN
LUMINAIRES.
Follow package dir Follow package dir Follow package dir Follow package dir Follow package directions, wear gloves, do not ections, wear gloves, do not ections, wear gloves, do not ections, wear gloves, do not ections, wear gloves, do not
touch bulb with your bar touch bulb with your bar
touch bulb with your bare fingers. touch bulb with your bar touch bulb with your bar
• Replace inner cover by inserting the three
retaining tabs into the three slots and pressing
them firmly in place.
ectly befor ectly before e e e e ectly befor
ectly befor
e fingers. e fingers.
e fingers. e fingers.
Bulb
19 19
19
19 19