Dyn/Dly Screen; Dyn. Edit Page; Dynamics Processor Parameter Settings - Yamaha AW4416 Operation Manual

DYN/DLY screen

Dynamics processor parameter settings

[Function]
Set the dynamics processor param-
eters for the selected channel.
[Key operation]
• [DYN] key [F1] (Dyn. Edit) key
• Repeatedly press the [DYN] key
until the screen shown at the
right appears.
[Mouse operation]
M button DYN button
Edit tab
[Screen functions]
A
KEYIN SOURCE
Select one of the following key-in signals to
control the dynamics processor.
SELF (POST EQ)
The post-EQ signal of the same channel
SELF (PRE EQ)
The pre-EQ signal of the same channel
AUX 1 OUT
The signal being output to AUX bus 1
AUX 2 OUT
The signal being output to AUX bus 2
LEFT (POST EQ)
The post-EQ signal of the next channel to the
left
LEFT (PRE EQ)
The pre-EQ signal of the next channel to the left
LEFT (POST EQ) or LEFT (PRE EQ) cannot be
selected for input channel 1, monitor chan-
nel 1, or the stereo output channel.
Return channels 1/2 do not have dynamics
processors.
60
— Reference Guide

Dyn. Edit page

1
3
Dyn.
4
5
2
Tip!
If either one of two paired channels exceeds
the threshold level, both channels will oper-
ate simultaneously.
B
Channel
If LEFT is selected as the KEYIN SOURCE (1),
the key-in signal source channel will be shown
here.
C
ST LINK ON/OFF (stereo link on/off)
button
If this button is on, dynamics processor parame-
ter settings and operation will be linked for
adjacent odd-numbered
channels.
For the stereo out channel and for paired
channels, this Stereo Link setting will always
be on and cannot be defeated.
When Stereo Link is turned on, the dynamics
processor settings of the odd-numbered
channel will be copied to the even-num-
bered channel.
6 7
8
9
J
even-numbered