Rear Panel - Toshiba JK-MX16A Instruction Manual

Rear Panel

z ~ S CAMERA/LOOPING 1 to 16
These BNC connectors are used to connect the cameras and each has a looping output. The factory setting of
each 75 ohm termination is ON. Two DIP switches inside the unit determine whether the termination is ON or OFF
for each camera input.
D MAIN
Main monitor output connector (BNC); connect it to the main monitor.
F RECORDER IN
Recorder input connector (BNC); connect it to the video output of the VCR etc.
G COM
Use this to connect a personal computer for controlling the multiplexer.
H ALARMS/TRIGGER
This connector is used for all alarm inputs, outputs, and also contains the input (REC Trigger In) for synchronizing
VCR to multiplexer. If using a Toshiba time-lapse recorder, a synchronization cable is not required
J CALL
This is the call monitor output (BNC) connector. This output is limited to display live full screen images.
K RECORDER OUT
Recorder output connector (BNC); connect it to the video input of VCR etc.
L MAIN
Main monitor output connector (S-video connector); connect it to the main monitor.
? RECORDER IN
Recorder input connector (S-video connector); connect it to the S-video output of the VCR etc.
Z RECORDER OUT
Recorder output connector (S-video connector); connect it to the S-video input of the VCR etc.
X 5 V DC
Accept the power plug of AC adapter.
- 10 -