Siemens SICLOCK TC 400 Operating Instructions Manual page 67

Table 7-5 Problem solutions for the configuration tool
Question/Problem
Parameters are displayed without value
© Siemens AG 2007 All Rights Reserved
®
SICLOCK TC 400
The authorization level has been raised after a download so that higher autho-
rized parameters are now shown. However, no value was supplied for these
parameters in the lower authorized request.
You can refresh these values with the
See
Parameters (Section 7.3),
Authorization (Section 7.2.2) and
Reading parameters / writing parameters / resetting parameters to factory
settings (Section 7.3.4).
Cause/Remedy
button or read them individually.
Configuration Tool
7-65