Starting The Product; Stopping The Product - Toro 51938 Operator's Manual

_WARNING:
The product may throw objects during
operation, causing injury to the operator or to
bystanders,. Always wear suitable eye protection,
long heaW pants, and boots while operating the
product..
Starting the Product
See Figure 14a, Figure t 4b, and Figure 15.
Starting the product differs depending on whether the
engine is cold or warm, Refer to the label on the air filter
coven,
To Start a Cold Engine
Follow these steps to start a cold engine.,
1. Lay the product on a flat, bare surface.
2. Toggle the switch to the i (ON) position,,
3. Push the primer bulb approximately eight times,,
4. Set the choke lever to A (Choke Closed).,
5. Press the lo&-offbutton and squeeze the trigger.
6,, Pull the starter cord three times..
7. Set the choke lever to B (Choke Open),,
8. Press the lock-off button and squeeze the trigger.,
9. Pull the starter cord
Note: If the product starts, let it run for 30 seconds
before using it., If the product does not start, repeat
the previous steps.
Switch Lock-off
Button
I
Set Choke to A
Set Choke to B
To Start a Warm Engine
Follow these steps to start a warm engine,
1,
2.
3.
4.
5.
6.
Figure 14b
lay the product on a flat, bare surface
Toggle the switdl to the i (ON) position
Push the primer bulb up to eight times
Set the drake lever to B (Choke Open),.
Do not squeeze the trigger_
Pull the starter cord,
Note:
If the product does not start, repeat the previ-
Otis steps,
Stopping the Product
See Figure 15
Follow these steps to stop the product,
1. Release r_e trigger,,
2. Toggle the switch to the 0 (OFF) position,,
Trigger
Primer
Bulb
Cord
Figure 14a
Figure 15
Operation 17