Status M Essage - Kenwood NEXEDGE NX-700 series Instruction Manual

■ Identification Codes
An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.
Each transceiver must have its own Fleet and ID number.
• Enter a Fleet number (00 ~ 349) to make a group call.
• Enter an ID number (000 ~ 4999) to make an individual call in your fleet.
• Enter a Fleet number to make a call to all units in the selected fleet (Fleet call).
• Enter an ID number to make a call to the selected ID in all fleets (Supervisor call).
• Select "ALL" Fleet and "ALL" ID to make a call to all units (Broadcast call).
Note: The ID range may be limited by programming.
S m
TATuS eSSAge
You can send and receive 2-digit Status messages which may be decided in your
talk group. Messages can contain up to 6 alphanumeric characters. Status
messages range from 0 to 99 (80 ~ 99 are reserved for special messages).
A maximum of 5 received messages can be stored in the stack memory of your
transceiver. These saved messages can be reviewed after reception. Depending
on your dealer settings, when the stack memory is full, either the oldest message
will be erased when a new message is received or the new message will not be
stored in the stack memory. The
stack memory.
■ Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status mode or Selcall +
Status to enter Selcall mode.
• When using the Status key to enter Status mode, the target Fleet/ ID is fixed and
cannot be selected. Skip to step 5 to continue.
3 In Selcall mode, press the
to call.
• If Manual Dialing is enabled, you can enter the station ID by using the
microphone keypad, or by using
cycle through the digits to select a digit, then press the
the digit and move the cursor to the right. Repeat this process until the
entire ID is entered.
4 Press the
5 Press the
• If Manual Dialing is enabled, you can enter the station ID by using the
microphone keypad, or by using
cycle through the digits to select a digit, then press the
the digit and move the cursor to the right. Repeat this process until the
entire ID is entered.
6 Press the microphone PTT switch or the
• "<<COMPLETE>>" is displayed when the call has been successfully transmitted.
8
/
key enter Status mode.
/ keys to select the status ID you want to transmit.
icon lights when a message is stored in the
keys to select the ID of the station you want
the / keys. When using the
the / keys. When using the
key to initiate the Status call.
/ keys,
key to set
/ keys,
key to set