Yamaha RX-V571 Owner's Manual page 16

Connecting speakers
Connecting speaker cables
Each speaker has two speaker cables. One is for
connecting the - (negative) terminal of the unit and the
speaker, and the other is for the + (positive) terminal.
The cables are different colors, so they do not get mixed
up. Connect the black side to the - (negative) terminal
and the other side to the + (positive) terminal.
Remove approximately 10 mm (0.4 in.) of insulation
from the end of the speaker cable and twist the bare
wire firmly.
Loosen the speaker
terminal. + (Red)
Insert the bare wire
into the gap on the
side of terminal.
When it is difficult to - (Black)
insert the wire into the
gap on the side,
insert it into the gap downside of terminal.
_Tighten the terminal.
Connecting with a banana plug (Except for U.K.,
Europe, Asia and Korea models)
Tighten the knob, and then insert a banana plug into the
end of the terminal.
Connecting front speakers
compatible with bi-amp
connection
When you use front speakers that support bi-amp
connection, connect the speakers to FRONT terminals
and SURROUND BACK/BI-AMP terminals.
To activate the bi-amplification connections, set the "BI-
AMP" (p.77) to "ON" in the "ADVANCED SETUP" menu
after connecting the power plug.
The unit (rear)
® ,-, o .....................
bl
NOTES
• Before making the bi-amplification connections, remove any
brackets or cables that connect a woofer with a tweeter. When
not making bi-amplification connections, make sure that the
brackets or cables are connected before connecting the speaker
cables. Refer to the instruction manual of the speakers for more
detail.
• When making the bi-amplification connections, the surround
back speakers are not available.
Connecting a subwoofer
Use monaural pin cable to connect a subwoofer.
Before connecting a subwoofer, turn off the subwoofer.
En
16