Table of Contents
Advertisement
Tiffs function enables you to set a recording length sim-
ply by pressing the REC/OTR button on the TV/VCR.
Make sure ...
• Power must be turned on.
• Insert a cassette tape with its erase prevention tab in
place. (If necessary, rewind or fast forward the tape
to the point at which you want to begin recording.)
NOTE:This function cannot be done by the remote con-
trol.
1 Select the channel to be recorded
Press number buttons on the remote control or the
CHANNEL • or • button.
2
Begin
OTR
F
Press REC/OTR button on the °1°'"_ _°'
TV/VCR
as many times
as
needed. The recording
length
will be determined by the num-
ber of times you press REC/OTR
button.
Each addilional push will increase the recording time by
30 minutes. It is set up to 8 hours.
. Push(es)
Display[
Recording length
1 pu.sh
(normal recording)
j
• 2 pushes
.... 0:3()
_
--
--"
....
]
30 minutes
i 3pusims-l---1-_--
7
---
60 minutes
HINTS:
• Recording starts immediately when the REC/OTR
button is pressed.
• When REC/OTR button is pressed 18 times, the
TV/VCR will switch to the Normal Recording mode.
• To stop the OTR operation, press STOP button oil the
TV/VCR or on the remote control.
• To show the remaining time, press SELECT button
repeatedly until "OTR" appears on the TV screen.
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode maximum record-
ing time, assuming the tape is started at the begin-
ning, is 8 hours using T- 160 (or 6 hours using T- 120).
• If the tape runs out before the end time, the TV/VCR
will switch to the Stop mode immediately, eject the
tape and the TV/VCR power will be turned off.
Connect your TV/VCR and a Source (Playing) VCR us-
ing the following diagram.
[The TVNCR]
AudioNideo
adapter
cord
(not supplied)
I.--J
[I--x: Source (Playing) VCR]
1) Insert a pre-recorded video cassette into the Source
(Playing) VCR.
2) Insert a blank video cassetle, c,rone you want to record
over, into the TV/VCR's cassette compartment.
3) Press SPEED button to select the desired recording
speed (SP, LP or SLP).
4) Press CHANNEL • or • button repeatedly so that
"AUX" appears on the screen.
5) Begin playback of the tape in the Source (Playing)
VCR.
6) Press REC button on the TV/VCR.
NOTE:
For best resul|s
duIing dubbing,
use the
TV/VCR's front panel controls whenever possible. The
remote control might affect 1he Source (Playing) VCR's
playback operation.
- 24 -
Advertisement
Table of Contents
