Download Print this page

GE PDS20MBWBWW Owner's Manual And Installation Instructions page 4

Bottom freezer

Advertisement

Available languages

Available languages

About the controls with
temperature setting&
(forother models, see next page)
NOTE: Therefrigerator is shipped wilt7protective film covering ttTetemperature controls.
If ttTis film was not removedduring installation, remove it now
The temperature controls are preset in the factory at 37°t: for the refrigerator compartment
and O°F for the freezer compartment. Allow24 hours for the temperature to stabilize to the
preset recommended settings.
The temperature controls can display both the SET temperature as well as the actual
temperature in the refrigerator and freezer. The actual temperature may vary slightly from
the SET temperature based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power to the refrigerator.
Changing the Temperature
To change the temperature,
press and release the
WARMER
or COLDER pad.
The
SETlight
will come
on and
the
display
will show
the
set temperatm'e.
To change
the
temperature,
tap
either
the
WARMERor COLDER
pad
tmfil
the
desired
temperatm'e
is displayed.
Refl_igerator
temperatm'es
can be ac!iusted
between
34°F and
47°F and
the
fl'eezer
teInI)eratures
can be ac!iusted
between
-6°F
and
+8°E
Once
the
desired
temi)eratm'e
has been
set,
the
temperatm'e
display
will retm'n
to the
actual
refl]gerator
and
fl'eezer
tenq)eratures
after
B
seconds.
Several
ac!jusmlents
may be required.
Each time you ac!iust controls,
allow 24 horns fiw the
refrigerator
to reach
the temperatm'e
you have set.
Toturn the cooling system off, tap the WARMER pad
fbr either
the refl_igerator
or the fl'eezer
tmtil the
display shows OFF.To turn the unit back on, press the
COLDERpad flw either
the refl'igerator
or fl'eezei:
The SETlight will ilhmfinate
on the side you
selected.
Then
press the COLDERpad again
(on the
side where
the SETlight is illuminated)
and it will
go to the preset points
of O°Ffiw the fl'eezer
and
37°Ffi)r the refl_igeratm:
Setting
either
or both
controls
to Off stops cooling
in both the fl'eezer
and refi'igerator
compartments,
but does not shut
off electrical
power
to the refl'igeratm:
Performance Air Flow System
The Pex-fbmaance
?dr Flow System
is designed
to
maximize
teml_eratm'e
control
in the
refl_igerator
and
fl'eezer
compartments.
This
tmique
special
teatm'e
consists
of the
_&JrTower
along the back
wall of the
refl'igerator
and
the _Mr Tmmel
on the
bottom
portion
of the
fl'eezer
rear
wall. Placing
food
in fl'ont
of the lou\'e_
on these
components
will not
affect
perlbm_ance.
4

Advertisement

loading