Table of Contents
Advertisement
STEP 9: (SEE FIGURE 9)
Align the holes in the handle with the holes in the
bottom of the poly tray, the latch stand plate and the
latch stand bracket. Fasten together using four 1/4"
x 1-3/4" hex bolts (D), 1/4" flat washers (I) and 1/4"
nylock nuts (J). Tighten.
•
At this time tighten
all bolts which were left loose.
WASHER
(D) 1/4" x 1-3/4"
HEX BOLT
(j) 1/4,,-.---_9,
NYLOCK
NUT
STEP 10: (SEE FIGURE 11)
Assemble the hitch pin (Q) through the tongue and
hitch bracket and secure it with the 1/8" hairpin cotter
(M).
HITCH
BRACKET
(M) 1/8" HAiRPiN
COTTER
FIGURE 11
FIGURE 9
CART WiTH TONGUE ARRANGED
FOR TOWING
STEP 11: (SEE FIGURE 12)
Attach two noise reduction pads (R) on each side of
the front tongue.
(H) 3/8" x 1"
/
CLEVIS PiN
/
(G) 3/8" x 4"
CLEVIS PiN
LATCH LOCK
FRONT
TONGUE
FIGURE 10
FIGURE 12
PADS (R)
PADS (R)
Advertisement
Table of Contents
