Lid Assembly; Power Head Assembly - Craftsman 113.170660 Owner's Manual

Assembly (continued)
Lid Assembly
1. Line up front (label) of lid with drain
cap and Vac port located on the front
of the drum.
NOTE: Lid must be aligned with drum for
proper attachment.
2. Place lid assembly on top of the drum.
3. Be sure lid completely covers the top
of the drum so leakage does not
OCCUr.
4. Upon releasing flexible latches, the lid
with attach to the drum.
5. To remove the lid, lift up on the flexible
latches and remove from drum.
c Label
.................................................................................... ___t J_lniet
: Drain
Power Head Assembly
1,
2.
Locate the detachable blower of your
Craftsman Wet/Dry Vac.
On top of the blower (opposite the
handle side of the blower); there is
molded plastic lead that is used to
assist assembling the unit. Position
the lead into the indented area above
the label.
3,
4.
Rotate the detachable blower down
until the travel of the unit stops.
Lightly press down on the carry handle
of the detachable blower until the
power head latch engages the blower.
The detachable blower is now latched
to the lid assembly.
Plastic
Lead
indented
Area
Flexible
L
Power
Latch