Charging Your Screwdriver - Craftsman 315.111810 Owner's Manual

CHARGING YOUR SCREWDRIVER
Your screwdriver has been shipped in a low charge
condition to prevent possible problems. Therefore,
you should charge it at least 3 hours prior to use.
Note: Batteries will not reach ful! charge the first time
they are charged. Allow several cycles (driving
screws followed by recharging) for them to become
fully charged.
If the charger does not charge your screwdriver under
normal circumstances, return both the screwdriver
and charger to your nearest Sears repair center for
electrical check.
CHARGING STAND
See Figure2.
CHARGING
PILOTHOLES
.s
SCREWS
WALL
ANCHORS
BIT
CHARGE
UGHT(LED)
BR
STORAGE
AREA
CHARGER
BO'I'rOMOF
CHARGING STAND INPUT
CHARGER PLUG
Fig. 2
For storage convenience,a charging stand with bit
storage has been providedwith your screwdriver. It
has the capacity of storingyour screwdriver and two
(2) bitswhich are also included with your screwdriver.
TO MOUNT CHARGING STAND
See Figures 2 and 3.
2-3/8 in.
BACK SIDE OF CHARGING STAND Fig. 3
• Locate close to an electrical outlet.
Note: Temporarily place your screwdriver in
charging stand. Check to make sure it will not
interfere with the charger or electrical outlet.
• Drill two (2) pilot holes then insert the two (2)
wall anchors provided.
Note: Pilot holes should be 2-3/8 inches apart.
See Figure 3.
• Position charging stand on wall aligning holes in
charging stand with pilot holes.
• Secure charging stand with the two (2) screws
provided.
TO CHARGE
• Place the forward/reverse switch in center
position.
• Place screwdriver in chargingstand.
Note: Screwdrivermust be in charging stand to be
charged.
• Insert charger plug into inputjack making sure
they are propertyconnected.
• Charger can be used with normal house
voltage of 120 volts, 60 Hz, AC only.
• Connect charger to power supply.
• The charge indicatorlight(LED) indicator, which is
located on the charging stand, will light up when
charger is propedy connected to power supply.
This red light indicatesyour screwdriveris charg-
ing and will remain on untilcharger is discon-
nected from power supply.
• After normal usage, a minimumof 3 hours of
chargingtime is required to be fully charged.
• DO NOT place charger in an area of extreme heat
or cold. It works best at normal room temperature.