This USE & CARE MANUAL provides specific operating instructions for your model. Use the room air conditioner only as instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced...
CAUTION. I Avoid Injury or damage to the unit or other property Provide occasional ventilation during use. Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups or make units run excessively. Do not climb on or place objects on outdoor...
Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company. Packaging Remove all packaging from inside the carton,...
Page 5
ELECTRONIC CONTROL Air Conditioner Features Before you begin, thoroughly familiarize yourself with the control panel and remote LIGHT as shown below and all its functions, then follow the symbol for the functions you ON/OFF desire. The unit can be controlled by the touch pad alone or with the remote. A D]U STS ADJUSTS HEATING INDICATOR...
Page 6
Operating Instructions (continued) TO CHANGE TEMPERATURE SETTING, YOU WILL SEE: DO THIS; PRESSTO RAISE PRESSTO LOWER ( v ) Note: Tap or hold either up (A) or down button until the desired temperature is seen on the display. This temperature will be automatically maintained...
Page 7
Operating Instructions (continued) TO OPERATE ON FAN ONLY: YOU WILL SEE: LIGHT ON DO THIS: PRESS MODE BUTTON CHOOSE FAN ONLY Note: Use this function only when cooling is not desired, such as for room air circulation or to exhaust stale air on some models.
Page 8
Operating Instructions (continued) CHECK FILTER FEATURE: YOU WILL SEE: LIGHT OFF LIGHT ON DO THIS: PRESS CHECK FILTER < (> BUTTON Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) will illuminate after 250 hours of operation.
Page 9
Operating Instructions (continued) REMOTE SENSING FEATURE (on some models): LIGHT pulsi ( On & Off intermittently DO THIS: SENSING PRESS REMOTE START BUTTON NOTE: Remote display NOTE: Unit display shows the set temperature is actual temperature Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
Page 10
If the display reads "HS", a sensor has If the display reads "AS", a sensor If the display reads "ES", a sensor failed. Contact your Authorized Frigidaire failed. Contact your Authorized Frigidaire failed. Contact your Authorized Frigidaire Service Center. Service Center.
Care and Cleaning Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent shock or fire hazards, Air Filter Cleaning The air filter should be checked at least once a month to see if cleaning necessary.
Page 12
Room too cold. Set temperature too low. Increase set temperature. Remote Sensing activated (on some models) and remote control located in Hot Spot - Relocate remote control or deactivate remote sensing. If These Solutions Fail, Call 1=800-944=9044 For Frigidaire Service,...
Page 13
Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.