Advertisement
TOOLS
REQUIRED
FOR ASSEMBLY
(1)
Pliers
(2)
7/16" Wrenches
(2)
1/2" Wrenches
(2)
9/16" Wrenches
REMOVAL
OF PARTS FROM CARTON
Remove all parts and hardware packages from the
carton. Lay out all parts and hardware and identify using
the illustrations on pages 3.
STEP 1 :
o
o
(SEE FIGURE 1)
Turn the spreader upside down.
Remove the lock nut from the middle bolt in the
crossover tube and shaft support plate. Leave the bolt
in place.
Assemble the hitch tube onto the middle bolt and
secure it with the same lock nut you removed, DO
NOT TIGHTEN YET.
_
MIDDLE BOLT
I
I
FIGURE 1
STEP 2: (SEE FIGURE 2)
Assemble the OUTER hitch braces to the hitch tube
using a 1/4"x 1-3/4" hex bolt and a 1/4" nylock hex
nut. DO NOTTIGHTEN
YET. Do not assemble the
inner hitch braces at this time,
114 NYLOCK
NUT
FIGURE 2
STEP
3: (SEE
FIGURE
3)
=
Assemble a spacer, a washer, a wheel (air valve
facing out) and another washer onto the end of the
axle that has only the small hole.
=
Install a 1/8" x 1-1/2" cotter pin into hole in the axle.
SPACER
WASHER
WHEEL
WASHER
1/8 x 1-1/2
COTTER PIN
FIGURE 3
4
Advertisement
