Advertisement
,
m,_
ii ,
i
OPERATING INSTRUCTIONS
AND PARTS LIST FOR
C RAFTS MAN
[.AT H !
12 INCH SWING, 36 INCHES BETWEEN CENTERS
MOD|IL
NUMBER
113.23881
The model number of your Lathe will be found stamped on the back of the
Headstock cover. Always mention this model number when communicating
with us regarding your Lathe or when ordering parts.
HOW
TO ORDER R|PAIR
PARTS
All paris listed herein may be ordered through SEARS, ROEBUCK AND CO.
or SIMPSONS-SEARS LIMITED. When ordering parts by mail from the mail
order house which serves the ter_ritoryin which you live, selling priceswill be
furnished on request or parts will be shipped at prevailing prices and you will
be billed accordingly.
WHEN
ORDERING REPAIR PARTS, ALWAYS
GIVE THE FOLLOWING
INFORMATION
AS SHOWN
IN THIS LIST:
1. The PART NUMBER.
2. The PART NAME.
3. The MODEL NUMBER-113.2388t
4. The NAME of item-LATHE,
SEARS,
ROEBUCK
AND
CO.
and
StMPSONS-SEARS LIMITED in Canada
back up your investmentwith quick, ex-
pert mechanical
service and genuine
CRAFTSMAN replacement parts.
If and when you need repairs or service,
call on us to protect your investment in
this fine piece of equipment.
S AR$, R OmUCK AND co.- u.s.A.
JN CANADA,
SIMPSONS-SEARS
LIMtT|D
SOURCE
FORM 756929
Lithographed
in UoS.A.
Advertisement
Related Manuals for Craftsman 113.23881
Summary of Contents for Craftsman 113.23881
- Page 1 StMPSONS-SEARS LIMITED in Canada back up your investmentwith quick, ex- pert mechanical service and genuine CRAFTSMAN replacement parts. If and when you need repairs or service, call on us to protect your investment in this fine piece of equipment. S AR$, R OmUCK AND co.- u.s.A.
-
Page 2: Product View And Main Parts
LRST FOR !i i:i! OPERATi N € PART5 HEADSTOCK i.DEXING CENTER HANDWHEEL )STOCK SPINDLE TAILSTOCK REST TAILSTOCK RAM CUP CENTER TAILSTOCK LOCK TOOL REST FOOT LOCK TOOL SLIDE CLAMP LOCK • i_:: LATHE BED TAILSTOCK LOCK FIGURE hex wrenches have been placed in the in- . - Page 3 Under normal conditiotas, best results will be ob- allowed to project through casting into tained by using a 1/3 horsepower 1750 R.P,M. hole in the pulley, locks the entire turning assembly motor. For continuous heavy duty work, a _ horse- attached to the spindle.
-
Page 4: Operation
spear point is used in a scraping manner TURNING CHISELS: feeding point::directly into work piece with five basic types df turning chisels are shown the beveled side down. Figure They available in various sizes indi- The round nose chisel is recommended for cutting vidually, or in matched... -
Page 5: Safety Precautions
€ontinuous:cuts_ donor start a Cut at the of:a:work: pietse during roughing: Work with the gouge chisel shorter cuts starting in the body of the FIGURE piece prevertt splintering tearing_ too] rest parallel to the face of the work piece Vv'her_ the pieCe:has beenroughed to within shown... -
Page 6: Parts List
• : _. 7 ! 621/'r_ COMPLETE TOOL REST CLAMP ASSEMBLY PARTS WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING INFORMATION: The PART NUMBER. MODEL NUMBERm103.23881 The PART NAME. Name of Item--LATHE. Do not use Key Numbers when ordering Repair Parts, always use Part...