Table of Contents
Advertisement
BEVELCUTTING
See Figure 21.
To make the best possible cut, follow these helpful hints:
[] Align the line of cut with the inner blade guide notch on
the base when making 45 ° bevel cuts.
[] Make a trial cut in scrap material along a guideline to
determine how much you should offset the guideline
on the cutting material.
[] Adjust the angle of the cut to any desired setting be-
tween zero and 51.5 ° . Refer to "To Adjust Bevel
Setting" next.
TO ADJUST BEVEL SETTING
See Figure 22,
[] Remove battery pack from the trim saw.
[] Loosen bevel adjustment knob.
[] Raise motor housing end of saw until you reach de-
sired angle setting on bevel scale.
[] Tighten bevel adjustment knob securely.
_IL
WARNING:
Attempting a bevel cut without having
the bevel adjustment knob securely tightened can
result in serious injury.
TO BEVEL CUT
See Figure 23,
[] Hold the saw firmly with both hands as shown.
[] Rest the front edge of the base on the workpiece.
[] Start the saw and let the blade reach full speed.
[] Guide the saw into the workpiece and make the cut.
[] Release the trigger and allow the blade to come to a
complete stop.
[] Lift the saw from the workpiece.
BEVEL
ADJUSTMENTKNOB
BEVEL
SCALE /
BLADE
GUIDENOTCH
ALIGN iNNERBLADEGUIDENOTCHON SAW BASE WITH
LiNE OFCUTAS SHOWNWHENMAKING45° BEVEL CUTS
Fig. 21
LOWER
BLADE GUARD
Fig. 22
18
Hide quick links:
Advertisement
Table of Contents
