Restoring The Machine's Default Lan Settings To Perform Setup Again - Canon PIXMA MX340 Network Setup Troubleshooting

6-B
WPA/WPA2
1
Enter the network key in Passphrase (L).
• Enter upper and lower case letters of the alphabet correctly when the network key is
between 8 and 63 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 64 characters.
2
Select Dynamic Encryption Type (M), then click OK (N).
• When WEP (Transitional Security Network) is selected in AirPort Utility, select
AES(Secure Encryption).
Go to .
7
The Manual Setup screen returns. Click Connect.
• After that, follow the on-screen instructions to proceed with settings.

Disable
L
M
N

Restoring the Machine's Default LAN Settings to Perform Setup Again

Action
Follow the procedure below to restore LAN settings of the machine to the default state.
1
Use the Menu button to select Device settings.
2
Use the [ or ] button to select LAN settings, then
press the OK button.
3
Select Reset LAN settings, then press the OK button.
4
Select Yes, then press the OK button.
5
Make sure that the screen shown to the right appears.
• After a while, the Device settings screen returns. Press the
COPY button.
The LAN setting of the machine is now restored to the default state.
• Perform setup by following the procedures in "10 Set Up a Wireless Connection" on page 26 and
onward in the printed manual: Getting Started.
<Default State>
Wireless LAN
Inactive
SSID BJNPSETUP
Data encryption Inactive
TCP/IP setting Obtain an IP address automatically