Safety Precautions - Craftsman 320.48298 Product Manual

,_k WARNING: BE SURE to read and understand all instructions in this manual
before using this product. Failure to follow all instructions may result in hazardous
radiation exposure, electric shock, and/or bodily injury.
_lk CAUTION; DO NOT attempt to modify the performance of the laser device in
any way. This may result in a dangerous exposure to laser radiation.
_k WARNING: LASER LIGHT. LASER RADIATION. Avoid Direct Eye Exposure.
DO NOT stare into beam. Turn the laser beam on only when using this tool. Class Ilia
laser.
_k WARNING: Use of controls, adjustments, or the performance of pro-
cedures other than those specified in this manual may result in hazardous
radiation exposure.
,_ WARNING: The use of optical instruments such as, but not limited to, tale _
scopes or transits to view the laser beam will increase eye hazard.
This measuring tool has a built-in laser light. The laser is a Class Ilia and emits out-
put power of a maximum 2o5mW and 635-665nm wavelengths. These lasers do not
normally present an optical hazard. However, DO NOT stare at the beam, as this can
cause flash blindness.
The following label is on your laser measuring toot. It indicates
the location from which the laser measuring tool emits the laser
light. Be aware of the laser light location when using the tool.
Always make sure that any bystanders in the vicinity of use are
made aware of the dangers of looking directly into the laser.
. Do not remove or deface any product labels.
o Avoid direct eye exposure. The laser beam can cause
flash blindness_
o The laser on the laser measuring tool is not a toy.
Always keep it out of the reach of children. The laser
light emitted from this device should never be directed
towards any person for any reason.
° Do not operate the tool around children or allow
children to operate the tool.
• Do not place the tool in a position that may cause anyone
to stare at the laser beam, whether intentionally or
unintentionally.
= Do not use on surfaces such as sheet steel that have
!:: iAVO|D
EXPOSURE:
:La_J;er i*mliiitlon ts emittetl:
: i: ,font tlt!_ _per!twe i: :i:
!:! i LA_5"_Rt, D_! _N-OO_IOT _TANE :
i ;_: imo_t_o,Vicw_mC_v_r,
TIPs ded_e complies with pert
_5of the FCC R./e_ Opnmli_/_
iS subjecf to the fotMwing lwe
conditions; {It This device may
net cause h_tmfu! interference.
and (2) th_s device mum accept
any infedemnce received,
including inederence fhM may
I! +_]
shiny, reflective surfaces. The shiny surface could reflect the beam back at
the operator.
Always turn the laser tool off when not in use. Leaving the tool on increas-
es the risk of someone inadvertently staring into the laser beam.
48298 Manual_Revised_0749225 Page 3