Micro Adjust
Font
Pitch
Pause
Reset
1. Make sure paper is loaded and the printer is turned off.
2. Turn on the printer while holding down the LF/FF and
Pause buttons. The printer enters the Lock-out setting mode
and prints the instructions. (You'll need three sheets of A4 or
letter size single-sheet paper or three pages of continuous
paper that is at least 279 mm [11 inches] long and 210 mm
[8.3 inches] wide.)
3. Follow the instructions to change the settings as desired.
4. Turn off the printer.
See "Turning Lock-out mode on and off" on page 3-10 for
instructions on how to turn on Lock-out mode after you change
the Lock-out mode setting.
Emulating the Okidata Microline 320 Turbo
If you have the EPSON FX-880+, you can make it work like the
®
Okidata
different mode. In Okidata mode, the printer emulates Okidata
functions, and the following additional settings can be selected
in the default setting mode:
Feature
Software emulation
Auto tear off wait time
Bottom margin
Line spacing (lines per inch)
Paper out override
®
Microline
320 Turbo by turning the printer on in a
Locked
Locked
Locked
Unlocked
Locked
Printer settings in Okidata mode
IBM PPDS, EPSON ESC/P, Oki ML 320T
0.5 second, 1 second, 2 seconds,
Others
4.2 mm, 20 mm, 22 mm, 24 mm, Others
6 LPI, 8 LPI
Off (No), On (Yes)
Using the Control Panel
3-11