1. Manuals
  2. Brands
  3. Sony Manuals
  4. CD Player
  5. CDX-530RF - Compact Disc Changer System
  6. Installation/connections manual

Sony CDX-530RF Installation/Connections Manual

Compact disc changer system
Hide thumbs Also See for CDX-530RF:
Table of Contents

Advertisement

Quick Links

See also: Service Manual , Operating Instructions
SON3t:
3-_7.700.11/
Compact
Disc
Changer
System
Installation/Connections
CDX-530RF
Sony Corporation
© 2000

Advertisement

Table of Contents
loading

Related Manuals for Sony CDX-530RF

Summary of Contents for Sony CDX-530RF

  • Page 1 SON3t: 3-_7.700.11/ Compact Disc Changer System Installation/Connections CDX-530RF Sony Corporation © 2000...

  • Page 3: Parts List

    Parts list The numbers in the list are keyed to those in the instructions. ® ® ® ® ® ® ® CD changer • Choose the mounting location carefully, observing the following: -- Do not install the unit where; • the ambient temperature exceeds 55 _C (131 _).

  • Page 4: Reset Button

    Connections Caution • This unit is designed for negative ground 12 V • Be sure to connect the red power input lead to the DC operation only. positive 12 V power terminal which is powered • Before making connections, disconnect the earth when the ignition switch is in the accessory...
  • Page 5 to a metal point on the car First connect the black earth lead, then connect the yellow Black and red power input leads. Fuse to the +12 V power terminal which is powered at all times Be sure to connect the black earth lead first. 5,5 m Fuse to the +12 V power terminal which is powered when the...

  • Page 6: Fuse Replacement

    Relay box ® An adaptor (optional) may be necessary foryour car and car audio system. In such a case, consult 5.5 m your dealer. 5,5 rn Insert the connector until it locks. Wired Remote WARNING Plug the connector into the jack on the left side of the CD changer.
  • Page 7 Relay box ® 5,5 m CDc_n_r ARNING ug the connector into the jack the left side of the CD changer. ake sure that the catch of the nnector is secured in the hole xt to the jack. to where it is goingto be mounted...

  • Page 8: Changing The Transmitting Frequency

    Wired remote (RM-X87) DISC +/- Note The supplied wireless remote (RM-X89) can be operated almost like the wired remote (RM-X87). Changing the transmitting frequency Because this unit processes CD playback sound through an FM tuner, there may be interference no,he during CD playback. In such a case, change the frequency of the modulated RF signal...

  • Page 9: Changing The Output Level

    Changing the output level You can select the output level from the unit. Normally the unit is used at the initial output level; change the level if necessary. 1 Press _ for two seconds. 2 Press _ momentarily. LEYEL IInitial Setting 3 Press _ or _...

  • Page 10: Horizontal Installation

    Installation How to install the CD changer • When you install the CD changer, be careful not to damage wiring or equipment on the other side of the mounting surface. • The brackets (_) provide two positions for mounting, high and low. Use the appropriate screw holes according to your preference.
  • Page 11 Installation ¢ 3.5 mm (s/_zin.)

  • Page 12: Suspended Installation

    Suspended installation ¢ 3.5 mm (_/=in.) € 3,5 mm (Sl= po.) When the unit is to be installed under the rear tray or in the trunk, observe the following. • Choose the mounting location carefully so that the unit can be installed horizontally. •...
  • Page 13 SonyOline http://www.world.sony.com/ Sony Corporation Printed in USA...

Table of Contents