Sony Cyber-shot DSC-W370 Instruction Manual page 5

Note:
This equipment has htwn testt.d and found to comply with tilt' limits for a Ulass B digital
device, pursuant to Part 15 of tile PCC Rules.
These limits are designed to provide reasonable protection against harmful interl<.mnce in
a msidemial installation. This equipment generates, uses. and can radiate radio lYequency
energy and. if not installed and used ill accordance with the instructions, may cause
Imrmful interl<.mnce to radio communications. However. them is no guarantee that
interference will not occur ill a particular installation. If this equipment does cause harmful
imerl\.rence to radio or television reception, which can be determined by turning the
equipment off and on. the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate tile receiving antenna.
Increase the separation between tile equipment and receiver.
Connect the equipment into an outlet on a circuit diff<.mnt l¥om that to which tile
receiver is connected.
Consult the dealer or all experienced radio/TV technician lk_r help.
Tile supplied imerface cable must be used with tile equipment in order to comply with the
limits lk_r a digital device pursuant to Subpart B of Part 15 of F((7 Rules.
G B
Notice for the customers in the countries applying EU Directives
Tht' lnilll/ifal.-t/ll-t.r of this product is Sony (-'orporation. 1-7-1 Konan Minato-ku Tokyo.
108-0075 Japan. The Authorized Repmsemative for EM( and product sal<.ty is Sony
Deutschhmd GmbH. Hedelfinger Strasse 61. 70327 Stuttgart, Germany. For ally service or
guarantee matters please refer to tile addresses given ill separate service or guarantee
documents.
This product has been tested and %und compliant with tile limits set out ill tile EMC
Directive l\_r using connection cables shorter than 3 meters (9.8 feet).
Attention
Tile ek.ctromagnctic fiehls at the specific fr<.qut.nck.s may influenct, the pictur<' and so/ind
of this unit.
Notice
If static electricity or electl-onlagnctism causes datu trilnsft.r to discontinue midway (fail),
restart the application or disconnect and connect tile communication cable (USB, etc./
again.
GB
5