Toshiba PERCEPTION 4000 User Manual page 13

PERCEPTION 4000 PERCEPTION 4000
LINE APPEARANCE KEY LED INDICATIONS/FLASH RATES
STATE
Idle
Ringing/Recall
(Internal)
Ringing/Recall
(External)
I-Use
I-Hold
In-Use
In-Hold
ADVANCE TONE
Three short tones which indicate that a call is about to be routed through
a more expensive Least Cost Routing (LCR) route.
BUSY TONE
A repeating .5 second on, .5 second off tone which indicates that the
station or trunk you have dialed is busy or is in Do Not Disturb mode.
CALL WAITING TONE
Tones which indicate that another call is ringing on your prime line. One
short tone indicates that the other call is a station call, while two short
tones indicate that the other call is a trunk call.
DIAL TONE
Continuous tone; proceed with dialing.
MUSIC-ON-HOLD TONE
Continuous music that occurs when a station is placed on hold. This is
programmed in the PERCEPTION 4000 system as an alternative to quiet
tone for calls placed on hold.
OVERRIDE WARNING TONE
This tone will be heard by a party who is the subject of an Attendant
Override. The party will hear a dial tone burst before the override occurs.
GENERAL INFORMAITON GENERAL INFORMATION
FLASH RATE
Off
.5 on; .5 off; repeating
.375 on; .125 off; repeating
Steady on
.125 on; .125 off; 2.0 on; .125 off; repeating
Steady on
.05 on; .05 off; repeating
1-3