Epson C82305 Series User Manual page 21

5. Handshaking
Table 8. Handshaking
Using DTR protocol
Using X-ON/X-OFF
protocol
The DTR signal is always set to SPACE while X-on/
X-off handshaking is selected.
X-on/X-off characters will not be transmitted from TXD
while DTR handshaking is selected (TXD signal is
always set to MARK).
Note
Operation is not guaranteed when using the current loop
mode at rates over 1,200 BPS.
US-232D
The two signal
conditions at pm No.
11 and pin No. 20 are and pin No. 24 is as
as follows;
MARK-data entry is
disabled
SPACE-data entry is
enabled
Data transmitted from
pin No. 2 is controller
as follows;
X - O N < l l > H - d a t a
entry is enabled
X - 0 F F < 1 3 > H - d a t a
entry is disabled
18
Control Loop
The impedance
between pin No. 17
follows;
LOW(MARK)-data
entry is disabled
High(SPACE)-data
entry is enabled
Data transmitted by
the change of the
impedance between
pin No. 17 and pin
No. 24 is controlled a
follows;
X - O N < l l > H - d a t a
entry is enabled
X-OFF<13>H-data
entry is disabled
s