Download Print this page
Sony CDX-CA900 Installation/Connections
Sony CDX-CA900 Installation/Connections

Sony CDX-CA900 Installation/Connections

Fm/mw/lw compact disc player
Hide thumbs Also See for CDX-CA900:

Advertisement

FM/MW/LW
Compact Disc
Player
Installation/Connections
CDX-CA900
Sony Corporation © 2002
1
1
2
5
6
× 2
8
9
⊕ Κ3 × 12
Equipment used in illustrations (not supplied)
Front speaker
Rear speaker
Active subwoofer
3-241-107-21 (1)
Printed in Thailand
3
4
7
q;
Power amplifier
CD/MD changer
Rotary commander RM-X4S
2
A
B
Cautions
• This unit is designed for negative earth 12 V
DC operation only.
• Do not get the wires under a screw, or caught
in moving parts (e.g. seat railing).
• Before making connections, turn the car
ignition off to avoid short circuits.
• Connect the yellow and red power input leads
only after all other leads have been connected.
× 4
• Run all earth wires to a common earth
point.
• Be sure to insulate any loose unconnected
wires with electrical tape for safety.
Notes on the power supply cord (yellow)
• When connecting this unit in combination with
other stereo components, the connected car
circuit's rating must be higher than the sum of
each component's fuse.
• When no car circuits are rated high enough,
connect the unit directly to the battery.
Parts Iist (1)
The numbers in the list are keyed to those in the
instructions.
Caution
Handle the bracket 1 carefully to avoid injuring
your fingers.
AUDIO OUT
SUB OUT (MONO)
AUDIO OUT
REAR
BUS AUDIO IN
BUS CONTROL IN
BUS AUDIO IN
Source selector*
*
XA-C30
BUS CONTROL IN
Connection example (2)
Notes (2-A)
• Be sure to connect the earth cord before
connecting the amplifier.
• If you connect an optional power amplifier and do
not use the built-in amplifier, the beep sound will
be deactivated.
Tip (2-B-
For connecting two or more CD/MD changers, the
source selector XA-C30 (optional) is necessary.
Connection diagram (3)
1
To a metal surface of the car
First connect the black earth lead, then connect
the yellow and red power input leads.
2
To the power aerial control lead or power
supply lead of aerial booster amplifier
Notes
• It is not necessary to connect this lead if there
is no power aerial or aerial booster, or with a
manually-operated telescopic aerial.
• When your car has a built-in FM/MW/LW aerial
in the rear/side glass, see "Notes on the control
and power supply leads."
3
To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers. Connecting
any other system may damage the unit.
4
To the interface cable of a car telephone
5
To a car's illumination signal
Be sure to connect the black ground lead to it
first.
6
To the +12 V power terminal which is energized
in the accessory position of the ignition key
switch
Notes
• If there is no accessory position, connect to the
+12 V power (battery) terminal which is
energised at all times.
Be sure to connect the black earth lead to it
first.
• When your car has a built-in FM/MW/LW aerial
in the rear/side glass, see "Notes on the control
and power supply leads."
7
To the +12 V power terminal which is energised
at all times
Be sure to connect the black earth lead to it first.
FRONT
* not supplied
)

Advertisement

loading

Summary of Contents for Sony CDX-CA900

  • Page 1 BUS AUDIO IN Source selector* XA-C30 * not supplied BUS CONTROL IN CDX-CA900 Sony Corporation © 2002 Printed in Thailand Cautions Connection example (2) • This unit is designed for negative earth 12 V Notes (2-A) • Be sure to connect the earth cord before DC operation only.
  • Page 2 Supplied with XA-C30 Source selector (not supplied) Supplied with the CD/MD changer XA-C30 SUB OUT (MONO) BUS AUDIO IN AUDIO OUT RCA pin cord (not supplied) REMOTE IN /AUX IN FRONT Auxiliary optional equipment such as portable DVD player (not supplied) from car aerial AUDIO OUT...
  • Page 3 8. •Avoid installing the unit in areas subject to dust, rotary commander will not interfere with operating • your Sony dealer. dirt, excessive vibration, or high temperatures, Attach a piece of heavy duty tape etc. on the the car.