Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
(1)
Adjustable
Wrench
(1)
318" Open Er_d or Box Wrench
(1)
7/16"
Open Endor
Box Wrench
(1}
1/2"
Open End or Box Wrench
(1)
9/16"
Open
End or Box Wrench
(1)
Standard
Screwdriver
(1)
Pair of Pliers
Refer to carton contents figure on page 2 and figure
1 on page 3 for
parts and hardware
needed
to
assemble sweeper
housing.
1.
Remove the 5/16"hex
nuts, 5/16" lock washers
and 5/16" fiat washers from the two 5/16" x 1-3/4"
carriage bolts as shown
in figure
3. Assemble
the hitch tongue
to the sweeper,
reusing
the
same two
carriage
bolts,
flat
washers,
lock
washers
and hex nuts. Do not tighten
at this
time,
5116" FLAT WASHER
SWEEPER HOUSING
FIGURE 4
NOTE
Before assembling
the hitch bracket
to the hitch tongue, refer to figure 5
and page
11 to determine
which
position is required for your towing
vehicle.
SWEEPER HOUSING
5/16" x 1-3/4" CARRIAGE BOLT
HITCH TONGUE
5/16"
FLAT WASHER
5/16" LOCK WASHER
5/16" HEX NUT
FIGURE 3
2.
Attach
the brace rod to the square
hole in the
sweeper
housing,
using
two
5/16"
x 3/4"
carriage bolts (assembled
with the heads on the
inside of housing).
Two 5/16"
flat washers
and
5/16"
hex lock nuts are assembled
outside
as
shown. See figures 4 and 5. Do Not Tighten
At
This Time.
.
Assemble
the hitch bracket
to the hitch tongue
using a 3/8" x 3/4" hex bolt (in front
hole) and
a 3/8" hex lock nut as shown in figure 5. Next,
assemble
the brace rod over the back hole in
the hitch bracket
and fasten with the brace rod
clip, a 3/8" x 1-1/2" hex bolt and a 3/8" hex lock
nut. Do not tighten
at this time.
See figure 5.
SWEEPER HOUSING
BRACE ROD
HITCH
TONGUE
-._-
BACK
HOLE
HITCH POSITION "A"
SEE PAGE 11
3/8" HEX LOCK NUTS
FIGURE 5
4
Advertisement
Table of Contents
