Organization
This document is composed of the following four chapters:
●
Chapter 1 Hardware Configurations
This chapter describes the main components and the relative optional products that are
installed in the ETERNUS DX60 S2 Disk storage system.
●
Chapter 2 ETERNUS DX Disk Storage System Installation
This chapter describes the installation specifications, the installation environment, and the
power requirements.
●
Chapter 3 Connections
This chapter describes the configuration for each interface to connect to the ETERNUS DX60
S2 Disk storage system.
●
Chapter 4 Rack and Optional Product Installation
This chapter describes the requirements for rack installation.
This chapter also describes the standard installation rules (installation locations and installa-
tion order) of the optional products before shipment from the factory when the optional prod-
ucts are purchased with the ETERNUS DX60 S2 Disk storage system at the same time.
Naming Conventions
■
Abbreviations used in this manual
•
"ETERNUS DX Disk storage system" refers to the ETERNUS DX60 S2 Disk storage system.
•
"Host Bus Adapter (HBA)" refers to the interface module normally used by the server to
connect to the ETERNUS DX Disk storage systems.
A "FC card", "LAN card", "Network Interface Card (NIC)", or "SAS card" may be used instead,
depending on the server and interface.
•
Trademark symbols such as ™ and ® are omitted in this document.
ETERNUS DX60 S2 Disk storage system User's Guide -Site Planning-
4
Copyright 2012 FUJITSU LIMITED
About this Manual
P3AM-5492-04ENZ0