Safety Symbols For Your Tool; Safety Rules - Craftsman 320.19730 Operator's Manual

EXTENSION CORDS conL
z_WARNING:
Check extension cords before each use. if damaged reptace
immediately. Never use toot with a damaged cord since touching the damaged area
could cause electrical shock, resulting In serious injury.
SAFETY SYMBOLS FOR YOUR TOOL
The label on your too! may Include the following symbols.
V...................................................................................
Volts
A ................................................................... Amps
Hz ................................................................ Hertz
W.............................................................. Walls
mln ......................................................................... Minutes
,-_., . ................................................. Allemeling cunenl
................................ ................ Direct current
n.
....................................................................
No.bad
speed
i_ ........................................................................... .Class II conslruclion, Double Insulated
Jmin .................................................................... R evolullons or Slrokes per minute
Z_" .............................................. Indicates danger, warning or eaulion..
It means atlentIon! Your salary is involved
SAFETY RULES FORTHE USE AND OPERATION
OFTHE UNIVERSAL BENCHTOP TOOLWORK STAND
1.. ALWAYS set up the Universal SenchTopToolWork Stand on s hard. dry.
flat stable surface
2
BE SURE lheI lhe tool work stand is fully opened and locked into lhe proper "set-up"
position BEFORE mounting your bench lop power tool to the table top assembly
FOLLOW ALL set-up instructions on pages 9 through 13 in this operator's manual
3 ALWAYS properly attach the bench top power tool DO NOT atlempt to usa your toot
work stand with a power tool until the tool ts belted securely to the tabIe lop assembly
according to the instructions on page 14 in this operator's manual.
4 When using lhis tool work stand wilh a bench top power tool that has mounling holes
that DO NOT Ilne up with the p_'e--slotted holes in the tool work slend's table top
assembly, mount your power tool to a plywood mounting board (sold separately).
then mount plywood board and power tool to the table top assembly. See instructions
on page I5 of Ihis manual
5_ When operating a power loaf that is mounted to lhis 1ool work sland_ ALWAYS FOLLOW
ALL safety rules and Instructions in the operator's manual of the power toot.
6. When selling up your universal bench lop tool work stand and the power tool, ALWAYS
be sure you have the proper space around the work sland to safely operate the power
tool
7 ALWAYS check the work stand and potter tool for damaged parts, Before turther use
of the work stand or the tool if any pad is damaged it should be carefully checked
to determine if il will operate properly end perform its intended function,
-4